Crossref Citations
This article has been cited by the following publications. This list is generated based on data provided by
Crossref.
Kino, H.
2003.
Principle of orthogonalization for completely restrained parallel wire driven robot.
p.
509.
Lafourcade, P.
and
Llibre, M.
2003.
First steps toward a sketch-based design methodology for wire-driven manipulators.
p.
143.
Miyake, Y.
Nishiyama, K.
Makimura, S.
Kawamura, N.
Shimomura, K.
Kadono, R.
Higemoto, W.
Fukuchi, K.
Beveridge, J.L.
Ishida, K.
Matsuzaki, T.
Watanabe, I.
Matsuda, Y.
Sakamoto, S.
Nakamura, S.N.
and
Nagamine, K.
2003.
The muon science facility at the JAERI/KEK joint project.
Physica B: Condensed Matter,
Vol. 326,
Issue. 1-4,
p.
255.
Kobayashi, Hiroaki
and
Ozawa, Ryuta
2003.
Adaptive neural network control of tendon-driven mechanisms with elastic tendons.
Automatica,
Vol. 39,
Issue. 9,
p.
1509.
Wang Hongguang
Zhao Mingyang
Fang Lijin
Li Shujun
and
Zhang Bo
2003.
The mechanism and kinematics of a 3-DOF in-parallel actuated manipulator.
Vol. 2,
Issue. ,
p.
804.
Kino, H.
and
Setoguchi, T.
2003.
Development of a serial-link structural robot supported by wire cable drive actuators: a basic analysis of two-links robot with a wire cable.
Vol. 1,
Issue. ,
p.
854.
Chunping Sui
and
Mingyang Zhao
2004.
Control of a 3-DOF Parallel Wire Driven Stiffness-Variable Manipulator.
p.
204.
Fang, S.
Franitza, D.
Torlo, M.
Bekes, F.
and
Hiller, M.
2004.
Motion Control of a Tendon-BasedParallel Manipulator Using Optimal Tension Distribution.
IEEE/ASME Transactions on Mechatronics,
Vol. 9,
Issue. 3,
p.
561.
Merlet, J-P.
2004.
On Advances in Robot Kinematics.
p.
211.
Krut, S.
Company, O.
and
Pierrot, F.
2004.
Force performance indexes for parallel mechanisms with actuation redundancy, especially for parallel wire-driven manipulators.
Vol. 4,
Issue. ,
p.
3936.
Franitza, Daniel
and
Fang, Shiqing
2004.
Seilkraftoptimierung für redundante Parallelmanipulatoren mit Seilantrieben.
PAMM,
Vol. 4,
Issue. 1,
p.
155.
Mroz, Geoff
and
Notash, Leila
2004.
Design and prototype of parallel, wire‐actuated robots with a constraining linkage.
Journal of Robotic Systems,
Vol. 21,
Issue. 12,
p.
677.
Kino, H.
Yabe, S.
Honjo, N.
and
Kawamura, S.
2004.
A sensor-actuator map for organization of position sensor feedback control for multiple links structure / wire driven system.
Vol. 2,
Issue. ,
p.
551.
Kino, Hitoshi
Yabe, Shigeru
and
Kawamura, Sadao
2005.
A force display system using a serial-link structure driven by a parallel-wire mechanism.
Advanced Robotics,
Vol. 19,
Issue. 1,
p.
21.
Ou Ma
and
Xiumin Diao
2005.
Dynamics analysis of a cable-driven parallel manipulator for hardware-in-the-loop dynamic simulation.
p.
837.
Behzadipour, Saeed
and
Khajepour, Amir
2005.
A New Cable-Based Parallel Robot with Three Degrees of Freedom.
Multibody System Dynamics,
Vol. 13,
Issue. 4,
p.
371.
Ottaviano, E.
Ceccarelli, M.
Paone, A.
and
Carbone, G.
2005.
A Low-Cost Easy Operation 4-Cable Driven Parallel Manipulator.
p.
4008.
Kino, H.
Yahiro, T.
Takemura, F.
and
Morizono, T.
2006.
Adaptive Position Control for Fully Constrained Parallel Wire Driven Systems.
p.
79.
Diao, Xiumin
Ma, Ou
and
Paz, Robert
2006.
Study of 6-DOF Cable Robots for Potential Application of HIL Microgravity Contact-Dynamics Simulation.
Behzadipour, Saeed
and
Khajepour, Amir
2006.
Stiffness of Cable-based Parallel Manipulators With Application to Stability Analysis.
Journal of Mechanical Design,
Vol. 128,
Issue. 1,
p.
303.