Hostname: page-component-7479d7b7d-767nl Total loading time: 0 Render date: 2024-07-14T05:21:33.087Z Has data issue: false hasContentIssue false

The High Speed Flow of Gas Around Blunt Bodies

Published online by Cambridge University Press:  07 June 2016

Hyman Serbin*
Affiliation:
Hughes Aircraft Company, Culver City, California
Get access

Summary

A number of results derived by the author in earlier reports on the flow of air around blunt bodies moving at high speed are here collected in a unified analysis. The theory predicts in a satisfactory way the shock shape and detachment distance for two blunt bodies, a flat disc and a sphere. It is shown that the density ratio across a normal shock is a useful parameter, combining the effects of both the free stream Mach number and the ratio of specific heats.

Type
Research Article
Copyright
Copyright © Royal Aeronautical Society. 1958

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Note on page 313 * These earlier reports were prepared during 1956 under the auspices of the RAND Corporation of Santa Monica, California.

Note on page 313 † This is based on a constant rate of heat transfer. Actually, the rate increases as x decreases, again to the disadvantage of the tip.

Note on page 314 * According to the classical kinetic theory of gases, γ=l+2/n, where n is the number of degrees of freedom of the molecule. It appears that γ is closer to unity the larger n is, a condition which is brought about by suitably high temperatures. However, at still higher temperatures, complete dissociation takes place, leading to the value 5/3 for γ.

Note on page 317 * The results will turn out to be consistent with this assumption.

Note on page 325 * This value coincides with a result obtained by W. Hayes in an informal memorandum Sonic Aspects of Hypersonic Flow, Ramo-Wooldridge Corporation, 1955.

Note on page 326 * The abscissa shown in Fig. 4 is ξ modified by replacing K by K-1 (see Section 6).