Hostname: page-component-5c6d5d7d68-sv6ng Total loading time: 0 Render date: 2024-08-08T23:16:36.955Z Has data issue: false hasContentIssue false
  • English
  • Français

Stresses Round Pins in Holes

Published online by Cambridge University Press:  07 June 2016

H. L. Cox  and
A. F. C. Brown
H. L. Cox
Affiliation:
National Physical Laboratory
A. F. C. Brown
Affiliation:
National Physical Laboratory
Get access

Summary

The existing data relating to stresses round pins in holes are reviewed and co-ordinated.

The first part of the paper deals with pins of which the diameter is less than half the plate width and which are no better than a push fit in the hole; the second section deals with larger pins; and the third section deals with interference fit of the smaller pins. The theoretical background is sketched in two appendices, and the results of three series of photoelastic measurements of the effects of clearance of the pin in the hole are described.

Type
Research Article
Information
Aeronautical Quarterly , Volume 15 , Issue 4 , November 1964 , pp. 357 - 372
Copyright
Copyright © Royal Aeronautical Society. 1964

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Jessop, H. T., Snell, C. and Holister, G. S. Photoelastic Investigation on Plates with Single Interference-Fit Pins with Load Applied to Plate Only. Aeronautical Quarterly, Vol. VII p. 297, November 1956.CrossRefGoogle Scholar
Photoelastic Investigation on Plates with Single Interference-Fit Pins with Load Applied (a) to Pin Only and (b) to Pin and Plate Simultaneously. Aeronautical Quarterly, Vol. IX p. 147, May 1958.Google Scholar
2. Royal Aeronautical Society’s Fatigue Data Sheets.Google Scholar
3. Frocht, M. M. and Hill, H. N. Stress Concentration Factors Around a Central Circular Hole in a Plate Loaded Through a Pin in the Hole. Transactions of the American Society of Mechanical Engineers. Applied Mechanics, Vol. 62 p. A5, 1940.CrossRefGoogle Scholar
4. Timoshenko, S. and Goodier, J. N. Theory of Elasticity, p. 60. McGraw-Hill, 1951.Google Scholar