Hostname: page-component-848d4c4894-8bljj Total loading time: 0 Render date: 2024-06-28T18:07:15.405Z Has data issue: false hasContentIssue false
  • English
  • Français

The Boundary Layer on a Townend Surface

Published online by Cambridge University Press:  07 June 2016

J. C. Cooke  and
O. K. Jones
J. C. Cooke
Affiliation:
Royal Aircraft Establishment, Farnborough
O. K. Jones
Affiliation:
Royal Aircraft Establishment, Farnborough
Get access

Summary

Certain three-dimensional surfaces studied by Townend have the property that at every streamwise section a supersonic air stream is compressed isentropically in the form of a reversed Prandtl-Meyer flow. If all the compressions are centred on points lying on one straight line the flow is conical. Such a surface may be of use as an engine intake. In this paper an approximate boundary-layer calculation for such a surface is made for laminar flow with zero heat transfer in the conical case. It is found that under certain circumstances a useful amount of compression can be obtained before separation occurs (a pressure ratio of 6, for instance, for an initial Mach number of 10). Limiting streamlines are drawn and displacement thickness calculated for a typical case, and the Mach number at separation is determined for a range of initial Mach numbers and angles of sweep. Instability due to sweep is considered.

Type
Research Article
Information
Aeronautical Quarterly , Volume 16 , Issue 2 , May 1965 , pp. 145 - 158
Copyright
Copyright © Royal Aeronautical Society. 1965

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Townend, L. H. On Lifting Bodies Which Contain Two-Dimensional Supersonic Flows. R.A.E. Report Aero 2675, 1963.Google Scholar
2. Maskell, E. C. and Weber, J. On the Aerodynamic Design of Slender Wings. Journal of the Royal Aeronautical Society, Vol. 63 p. 709, December 1959.Google Scholar
3. Cooke, J. C. Approximate Calculation of Three-Dimensional Laminar Boundary Layers. R. & M. 3201, October 1959.Google Scholar
4. Stewartson, K. Correlated Incompressible and Compressible Boundary Layers. Proc. Roy. Soc. A, Vol. 200, 1949.Google Scholar
5. Rainbird, W. J., Crabbe, R. S. and Jurewicz, L. Z. The Flow Separation about Cones at Incidence. DME/NAE Quarterly Bulletin, No. 1963 (2), Ottawa, 1963.Google Scholar
6. Moore, F. K. Three-Dimensional Compressible Laminar Boundary-Layer Flow. N.A.C.A. T.N. 2279, 1951.Google Scholar
7. Hayes, W. D. The Three-Dimensional Boundary Layer. NAVORD Report 1313, 1951.Google Scholar
8. Hayes, W. D. and Probstein, R. F. Hypersonic Flow Theory. Academic Press, New York and London, 1959.Google Scholar
9. Owen, P. R. and Randall, D. G. Boundary-Layer Transition on a Swept Back Wing. R.A.E., Unpublished, June 1952.Google Scholar
10. Chapman, G. T. Some Effects of Leading-Edge Sweep on Boundary-Layer Transition at Supersonic Speeds. N.A.S.A. T.N. D-1075, September 1961.Google Scholar
11. Cooke, J. C. An Approximate Method of Calculating the Laminar Boundary Layer on a Delta Wing. R.A.E. Tech. Note Aero 2595, November 1958.Google Scholar
12. Cooke, J. C. Stewartson’s Compressibility Correlation in Three Dimensions. Journal of Fluid Mechanics, Vol. 11 p. 51, 1961.Google Scholar
13. Van Driest, E. R. Investigation of Laminar Boundary Layer in Compressible Fluids using the Crocco Method. N.A.C.A. T.N. 2597, January 1952.Google Scholar