Hostname: page-component-7479d7b7d-k7p5g Total loading time: 0 Render date: 2024-07-09T10:16:59.724Z Has data issue: false hasContentIssue false
  • English
  • Français

Correlation Between some Stability Problems for Orthotropic and Isotropic Plates under Bi-Axial and Uni-Axial Direct Stress

Published online by Cambridge University Press:  07 June 2016

W. H. Wittrick
W. H. Wittrick*
Affiliation:
Department of Aeronautical Engineering, University of Sydney
Get access

Summary

Four buckling problems are considered, namely: —

  • (a) A rectangular orthotropic plate, with all edges simply supported, subjected to compression on its ends and a known compression or tension on its sides;

  • (b) the same as (a) but with the ends clamped and sides simply supported;

  • (c) a rectangular orthotropic plate, with the ends simply supported and sides clamped, subjected to compression on its ends; and

  • (d) the same as (c) but with all edges clamped.

In each case it is shown that the variables involved can all be combined into such a non-dimensional form that a single curve serves to give the value of the end compression required to cause buckling. This curve is identical with the curve of buckling stress coefficient against side ratio for a corresponding isotropic plate under uni-axial compression.

Type
Research Article
Information
Aeronautical Quarterly , Volume 4 , Issue 1 , February 1954 , pp. 83 - 92
Copyright
Copyright © Royal Aeronautical Society. 1954

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Smith, R. C. T. (1944). The Buckling of Flat Plywood Plates in Compression. Australian Report ACA-12, 1944.Google Scholar
2. Timoshenko, S. (1936). Theory of Elastic Stability. McGraw-Hill, 1936.Google Scholar