Hostname: page-component-77c89778f8-m8s7h Total loading time: 0 Render date: 2024-07-23T09:43:59.771Z Has data issue: false hasContentIssue false
  • English
  • Français

Laminar throughflow between closely spaced rotating disks

Published online by Cambridge University Press:  12 April 2006

A. Z. Szeri  and
M. L. Adams
A. Z. Szeri
Affiliation:
Department of Mechanical Engineering, University of Pittsburgh, Pennsylvania 15261
M. L. Adams
Affiliation:
Department of Mechanical Engineering, University of Pittsburgh, Pennsylvania 15261 Present address: Department of Mechanical Engineering, University of Akron, Ohio.
Get access Rights & Permissions [Opens in a new window]

Abstract

Laminar throughflow between finite parallel disks, one stationary and the other rotating, can be characterized by four dimensionless parameters in the general case. But, if the ratio of disk spacing to disk radius is small, an approximate definition of the flow may be made with reference to a single parameter, the Ekman number. The equations of motion and the equation of continuity in this ‘thin-film’ approximation are reduced here to an initial-value problem for nonlinear ordinary differential equations, by a Galerkin-type procedure. Hamming's modified predictor-corrector method is employed subsequently to solve for the stream functions. Radial pressure profiles of this solution are compared with published experimental data. The calculated results may be applied to the design of hydrostatic bearings and face seals.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 86 , Issue 1 , 15 May 1978 , pp. 1 - 14
Copyright
© 1978 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Adams, M. L. 1977 Incompressible flow between finite disks. Ph.D. dissertation, University of Pittsburgh.
Coombs, J. A. & Dowson, D. 1965 An experimental investigation of the effects of lubricant inertia in hydrostatic thrust bearings. Proc. Inst. Mech. Engrs 179 (3), 96–108.Google Scholar
Dowson, D. 1961 Inertia effects in hydrostatic thrust bearings. J. Basic Engng, Trans. A.S.M.E. 83, 227–234.Google Scholar
Hunt, J. B. & Torbe, I. 1962 Characteristics of a hydrostatic thrust bearing. Int. J. Mech. Sci. 4, 503–516.Google Scholar
Jackson, J. D. & Symmons, G. R. 1965a The pressure distribution in a hydrostatic thrust bearing. Int. J. Mech. Sci. 7, 239–242.Google Scholar
Jackson, J. D. & Symmons, G. R. 1965b An investigation of laminar radial flow between two parallel discs. Appl. Sci. Res. A 15, 59–75.Google Scholar
Livesey, J. L. 1960 Inertia effects in viscous flows. Int. J. Mech. Sci. 1, 81–88.Google Scholar
Makay, E. 1967 Effect of inertia terms on a fully developed axi-symmetric laminar flow. Ph.D. dissertation, The University of Pennsylvania.
Moller, P. S. 1963 Radial flow without swirl between parallel discs. Aero. Quart. 14, 163–186.Google Scholar
Nirmel, C. N. 1970 An analytical and experimental investigation of viscous incompressible flow through narrow regions with and without rotating boundaries. Ph.D. dissertation, North Carolina State University. (Available from University Microfilms, Ann Arbor.)
Osterle, J. F. & Hughes, W. F. 1957/8 Inertia induced cavitation in hydrostatic thrust bearings. Wear 4, 228–233.Google Scholar
Savage, S. B. 1964 Laminar radial flow between parallel plates. J. Appl. Mech., Trans. A.S.M.E. 86, 594–596.Google Scholar
Szeri, A. Z. & Adams, M. L. 1976 Source flow between a stationary and a rotating disk. Mech. Res. Comm. 3, 231–232.Google Scholar