Hostname: page-component-7479d7b7d-fwgfc Total loading time: 0 Render date: 2024-07-12T03:00:03.347Z Has data issue: false hasContentIssue false
  • English
  • Français

Friction and wear studies of silicon in sliding contact with thin-film magnetic rigid disks

Published online by Cambridge University Press:  31 January 2011

Bharat Bhushan  and
Sreekanth Venkatesan
Bharat Bhushan
Affiliation:
Computer Microtribology and Contamination Laboratory, Department of Mechanical Engineering, The Ohio State University, Columbus, Ohio 43210-1107
Sreekanth Venkatesan
Affiliation:
Computer Microtribology and Contamination Laboratory, Department of Mechanical Engineering, The Ohio State University, Columbus, Ohio 43210-1107
Get access

Abstract

Silicon is an attractive material for the construction of read/write head sliders in magnetic recording applications from the viewpoints of ease of miniaturization and low fabrication cost. In the present investigation we have studied the friction and wear behavior of single-crystal, polycrystalline, ion-implanted, thermally oxidized (wet and dry), and plasma-enhanced chemical vapor deposition (PECVD) oxide-coated silicon pins while sliding against lubricated and unlubricated thin-film disks. For comparison, tests have also been conducted with Al2O3–TiC and Mn–Zn ferrite pins which are currently used as slider materials. With single-crystal silicon the rise in the coefficient of friction with sliding cycles is faster compared to Al2O3–TiC and Mn–Zn ferrite pins. In each case, the rise in friction is associated with the burnishing of the disk surface and transfer of amorphous carbon and lubricant (in the case of lubricated disks) from the disk to the pin. Thermally oxidized (under dry oxygen conditions) single-crystal silicon and PECVD oxide-coated single-crystal silicon exhibit excellent tribological characteristics while sliding against lubricated disks, and we believe this is attributable to the chemical passivity of the oxide coating. In dry nitrogen, the coefficient of friction for single-crystal silicon sliding against lubricated disks behaves differently than in air, decreasing from an initial value of 0.2 to less than 0.05 within 5000 cycles of sliding. We believe that silicon/thin-film disk interface friction and wear is governed by the uniformity and tenacity of the amorphous carbon transfer film and oxygen-enhanced fracture of silicon.

Type
Articles
Information
Journal of Materials Research , Volume 8 , Issue 7 , July 1993 , pp. 1611 - 1628
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1Bhushan, B.Tribology and Mechanics of Magnetic Storage De vices (Springer-Verlag, New York, 1990).CrossRefGoogle Scholar
2Lazzari, J. P. and Deroux-Dauphin, P., IEEE Trans. Magn. 25 (5), 3190–3193 (1989).CrossRefGoogle Scholar
3Bhushan, B.Dominiak, M. and Lazzari, J. P.IEEE Trans. Magn. 28 (5), 2874–2876 (1992).CrossRefGoogle Scholar
4Bhushan, B. and Venkatesan, S.Adv. Info. Storage Syst. 5 (in press).Google Scholar
5Bhushan, B. and Doerner, M.F.J. Trib., Trans. ASME 111, 452–458 (1989).CrossRefGoogle Scholar
6Jaeger, R. C.Introduction to Microelectronic Fabrication (Addison-Wesley, Reading, MA, 1989), Vol. V.Google Scholar
7Chu, M. Y.Bhushan, B. and Jonghe, L. C. De, Trib. Trans. 36, 84–94 (1992).Google Scholar
8Gupta, B. K.Chevallier, J. and Bhushan, B.J. Trib., Trans. ASME (in press).Google Scholar
9Mott, N.F.Philos. Mag. B55, 117–129 (1987).CrossRefGoogle Scholar
10Deal, B.E.J. Electrochem. Soc. 110, 527–533 (1963).CrossRefGoogle Scholar
11Wolf, H.F.Silicon Semiconductor Data (Pergamon Press, New York, 1969).Google Scholar
12Richards, C.Engineering Materials Science (Wadsworth Publishing Company, San Francisco, CA, 1961).Google Scholar
13Pilskin, W.A.J. Vac. Sci. Technol. 14, 1064–1081 (1977).CrossRefGoogle Scholar
14Beckmann, K. H. and Harrick, N. J.J. Electrochem. Soc. 118, 614–619 (1971).CrossRefGoogle Scholar
15Bayer, R.G.Wear 69, 235–239 (1981).CrossRefGoogle Scholar
16Marchon, B.Heiman, N. and Khan, M.IEE E Trans. Magn. 23, 168–170 (1990).CrossRefGoogle Scholar
17Novotny, V.J.Karis, T.E. and Johnson, N.W.J. Trib., Trans. ASME 114, 61–67 (1992).CrossRefGoogle Scholar