Hostname: page-component-7bb8b95d7b-qxsvm Total loading time: 0 Render date: 2024-09-09T12:37:28.003Z Has data issue: false hasContentIssue false
  • English
  • Français

On The Formation Of Diffusion Layer Between Cr Film And Glass

Published online by Cambridge University Press:  02 July 2020

N. Jiang  and
J. Silcox
N. Jiang
Affiliation:
School of Applied and Engineering Physics, Cornell University, Ithaca, NY14853USA
J. Silcox
Affiliation:
School of Applied and Engineering Physics, Cornell University, Ithaca, NY14853USA
Get access

Extract

Chromium films are commonly used as a metal “glue” layer because of good adhesion to glass. It is believed that an intermediate oxide layer is formed during deposition, since Cr has a very strong affinity for oxygen. For example, a graded Cu/Cr/CrOx/SiO2 structure ensures excellent adhesion of Cu to glass, whereas Cu exhibits poor adhesion to most dielectrics. In our recent study, however, a diffusion layer, Cr2O3+SiOy, was observed between CrOx and SiO2 (glass) substrate. It is quite likely that this diffusion layer is responsible for the good adhesion of Cr film to glass.

The relative compositions of the major components across the interface are shown in Fig 1. A Cr film was evaporated on Corning Code 1737 glass (Al2O3-B2O3-SiO2 with ˜67at.% Si02) substrate at room temperature (RT) and subsequently covered with about lOnm Cu. A 5nm'wide diffusion layer is seen. The corresponding regions are also indicated in Fig 2, an Annular Dark Field (ADF) image whose contrast is approximately proportional to the density if the thickness is assumed uniform.

Type
Atomic Structure And Microchemistry Of Interfaces
Information
Microscopy and Microanalysis , Volume 5 , Issue S2: Proceedings: Microscopy & Microanalysis '99, Microscopy Society of America 57th Annual Meeting, Microbeam Analysis Society 33rd Annual Meeting, Portland, Oregon August 1-5, 1999 , August 1999 , pp. 166 - 167
Copyright
Copyright © Microscopy Society of America

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Kellock, A. J. and Baglin, J. E. E., MRS Symp. Proc, 153 (1989) 391.CrossRefGoogle Scholar

2. Leapman, R. D. et al., Phys. Rev. B, 26 (1982) 614.CrossRefGoogle Scholar

3. Batson, P. E., Microsc MicroanaL,4 (1998) 794.CrossRefGoogle Scholar

4. This work is supported by NSF through the Cornell Center for Materials Research.Google Scholar