No CrossRef data available.
Article contents
Relationship Between High-Strain-Rate Superplasticity and Interface Microstructure in Aluminum Alloy Composites
Published online by Cambridge University Press: 02 July 2020
Extract
The Al alloy composites reinforced with Si3N4 or SiC have been reported to exhibit superplasticity at high strain rate of faster than 1x10−2 s−1. It has been shown in many aluminum alloy composites that the optimum superplastic temperature coincides with an incipient melting temperature. The coincidence suggests a contribution of the liquid phase to the superplasticity mechanism. This paper shows a direct evidence of partial melting along matrix grain boundaries and matrix-reinforcement interfaces. Based on the obtained results, the role of the liquid phase in the high-strain-rate superplasticity is discussed.
The sample was Al-Mg (5052) alloy reinforced with 20vol% Si3,N4 particles, fabricated by a powder metallurgy process. The sample showed an excellent superplasticity under the conditions given in Table 1. Partial melting was confirmed to occur at 821 K by differentail scanning calorimetry. The microstructural changes during heating were observed in situ by TEM using a heating stage. The structure of interfaces and grain boundaries was observed by HREM. Chemical analysis was performed with EDS attached to VG-STEM.
- Type
- Future of Microscopy: Ceramics, Composites, and Cement
- Information
- Copyright
- Copyright © Microscopy Society of America
References
This research was supported by the US DOE, OBES and by Japanese Ministry of Education.