Hostname: page-component-5c6d5d7d68-ckgrl Total loading time: 0 Render date: 2024-08-20T10:19:00.111Z Has data issue: false hasContentIssue false
  • English
  • Français

The effect of substrate temperature and interface oxide layer on aluminum induced crystallization of sputtered amorphous silicon

Published online by Cambridge University Press:  21 March 2011

Maruf Hossain ,
Husam Abu-Safe ,
Marwan Barghouti ,
Hameed Naseem  and
William D. Brown
Maruf Hossain
Affiliation:
Arkansas Advanced Photovoltaic Research Center, Department of Electrical Engineering 3217 Bell Engineering Center, University of Arkansas, Fayetteville, Arkansas 72701
Husam Abu-Safe
Affiliation:
Arkansas Advanced Photovoltaic Research Center, Department of Electrical Engineering 3217 Bell Engineering Center, University of Arkansas, Fayetteville, Arkansas 72701
Marwan Barghouti
Affiliation:
Arkansas Advanced Photovoltaic Research Center, Department of Electrical Engineering 3217 Bell Engineering Center, University of Arkansas, Fayetteville, Arkansas 72701
Hameed Naseem
Affiliation:
Arkansas Advanced Photovoltaic Research Center, Department of Electrical Engineering 3217 Bell Engineering Center, University of Arkansas, Fayetteville, Arkansas 72701
William D. Brown
Affiliation:
Arkansas Advanced Photovoltaic Research Center, Department of Electrical Engineering 3217 Bell Engineering Center, University of Arkansas, Fayetteville, Arkansas 72701
Get access

Abstract

The effect of substrate temperature and interface oxide layer on aluminum induced crystallization (AIC) of amorphous silicon (a-Si) is investigated. The effect of substrate temperature on the AIC process was studied by changing the deposition temperate of a-Si from 200 to 300°C in a Al/a-Si/glass configuration. To study the effect of interface oxide on AIC, samples with a-Si/Al/glass, a-Si/Al-oxide/Al/glass, and Al/Si-oxide/a-Si/glass configurations were prepared at a fixed substrate temperature. The samples were annealed in the temperature range from 300°C to 525°C for different periods of time. The X-ray diffraction (XRD) patterns confirmed the crystallization of the a-Si films in the various configurations. From the analysis, we report that crystallization of a-Si happen at 350°C annealing temperature in the Al/a-Si/glass configuration. However, with or without the presence of Si-oxide at the interface, crystallization saturated after annealing for 20 minutes at 400°C. On the other hand, when Al-oxide is present at the interface, higher annealing temperatures and longer annealing times are required to saturate the crystallization of a-Si. Environmental Scanning Electron Microscope (ESEM) and Energy Dispersive X-Ray (EDX) mapping were used to study the surface morphology as well as the layer sequence after crystallization. This analysis revealed that Si-Al layer-exchange happens regardless of the deposited film configuration.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 808: Symposium A – Amorphous and Nanocrystaline Silicon Science and Technology-2004 , 2004 , A4.22
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Werner, J. H., Bergmann, R., and Brendel, R., “The challenge of crystalline thin film silicon solar cell”, Advances in Solid State Physics, Helbig, R., Ed. Braunschweig, Germany, vol. 341, p. 115, 1995.Google Scholar
[2] Haque, M. Shahidul, Naseem, H. A. amd Brown, W. D., “Interaction of aluminum with hydrogenated amorphous silicon at low temperatures”, J. Appl, Physics, vol. 75, p.3928, 1994.Google Scholar
[3] Kishor, Ram, Shaik, Arshad, Naseem, H. A. and brown, W. D., “Atomic force microscopy and x-ray diffraction studies of aluminum induced crystallization of amorphous silicon in Al/a-Si:H, a-Si:H/Al, and Al/a-Si:H/Al thin film structures”, J. Vac. Sci. Techno. B, vol. 21, p. 1037, 2003.Google Scholar
[4] Saitoh, K., Kondo, M., Nishimiya, T., Matsuda, A., Futaco, W. and Shimizu, I., “Role of hydrogen plasma treatment in layer-by-layer deposition of microcrystalline silicon”, Appl. Phys. Lett., vol. 71, p. 3403, 1997.Google Scholar
[5] Sriraman, S., Sumit Agarwal, Aydil, E. S. and Maroudas, D., “Mechanism of hydrogen-induced crystallization of amorphous silicon”, Nature, vol. 418, p. 62, 2002.Google Scholar
[6] Matsumoto, Yasuhiro and Yu, Zhenrui, “P-type polycrystalline Si films prepared by aluminum induced crystallization and doping method”, Jpn. J. appl. Phys., vol. 40, p. 2110, 2001.Google Scholar
[7] Drusedau, Tilo P., Blasing, Jurgen and Gnaser, Hubert, “Aluminum mediated low temperature growth of crystalline silicon by plasma-enhanced chemical vapor and sputter deposition”, Appl Phys. Letters, vol. 72, no.12, p. 1510, 1998.Google Scholar
[8] Nast, O., Brehme, S., Neuhaus, Drik H. and Wenham, S. R., “Polycrystalline silicon thin films on glass by aluminum induced crystallization”, IEEE transactions on electron devices, vol. 46, p. 2062, 1999.Google Scholar
[9] Demichelis, F., Tagliaferro, A. and Tresso, E., “Magnetron-sputtered amorphous silicon”, J. Appl. Phys, Vol. 57, p. 5424, 1985.Google Scholar
[10] Iizima, S., Okushi, H., Matsuda, A., Yamasaki, S., Nakagawa, K., Matsumura, M. and Tanaka, K., “Preparation and characterization of reactively sputtered amorphous Si:H films”, Jpn. J. appl. Phys., vol. 19, p. 521, 1980.Google Scholar