Hostname: page-component-77c89778f8-7drxs Total loading time: 0 Render date: 2024-07-25T04:00:45.995Z Has data issue: false hasContentIssue false

Effect of Y-Doping on the Dielectric Properties of BatiO3 Films Deposited in Reducing Atmospheres Using Pulsed Laser Deposition

Published online by Cambridge University Press:  10 February 2011

Won-Youl Choi
Affiliation:
Materials Research Laboratory, The Pennsylvania State University, University Park, PA 16802
Yoed Tsur
Affiliation:
Materials Research Laboratory, The Pennsylvania State University, University Park, PA 16802
Clive A. Randall
Affiliation:
Materials Research Laboratory, The Pennsylvania State University, University Park, PA 16802
Susan Trolier-McKinstry
Affiliation:
Materials Research Laboratory, The Pennsylvania State University, University Park, PA 16802
Get access

Abstract

BaTiO3-based multilayer capacitors with Ni electrodes are fired at low Po2 to prevent the oxidation of Ni. Amphoteric dopants such as Y, Ho and Dy are used to prevent electrical degradation due to oxygen vacancy migration. This paper describes use of this approach in preparing thin film BaTiO3 capacitors. Tolerance of reducing atmospheres is particularly important in films which are co-processed with resistors such as TaN for integrated resistor-capacitor networks. To assess this approach, films with and without Y-doping were grown in pure N2 atmospheres by pulsed laser deposition from undoped and 0.2wt% Y2O3 doped BaTiO3 targets, respectively. Films were deposited onto Pt/Ti/SiO2/Si substrates using a 5∼10Hz laser repetition rate, an energy density of 4.2J/cm2 and a working pressure of 100mTorr. It was found that polycrystalline perovskite films could be grown at 700°C and that Y-doped films had better crystallinity than the undoped ones. The dielectric constants of films without and with Y-doping are ∼1100 and ∼1300 at lkHz, respectively. The dielectric losses of Y-doped films were lower than for undoped films, possibly because the concentration of mobile charges including oxygen vacancies was decreased. Y-doped films also have a smaller coercive field (25kV/cm) and higher maximum polarization (∼20μC/cm2) than undoped films. The defect chemistry of the system is also discussed.

Type
Research Article
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Hagemann, H.J., Hennings, D., and Wernicke, R., Philips Tech. Review, 41, 89(1983)Google Scholar
2. Burn, I., and Maher, G. H., J. Mater. Sci., 10, 633 (1975)Google Scholar
3. Sakabe, Y., Ceramic Bulletin, 66(9), 1338 (1987)Google Scholar
4. Waser, R., Baiatu, T, and Hardtl, K., J. Am. Ceram. Soc., 73[6], 1645 (1990)Google Scholar
5. Sato, S., Nakano, Y., Sato, A., and Nomura, T., Jpn. J. Appl. Phys., 36, 6016 (1997)Google Scholar
6. Nakano, Y., Sato, A., Hitomi, A., and Nomura, T., Ceramic Transactions, 32, 119 (1993)Google Scholar
7. Ito, A., Machida, A., and Obara, M., Appl. Phys. Lett., 70[25], 3338 (1997)Google Scholar
8. Davis, G. M., and Grower, M. C., Appl. Phys. Lett., 55[2], 112 (1997)Google Scholar
9. Norton, M. G., Scarfone, C., Li, J., Carter, C. B., and Mayer, J. W., J. Mater. Res., 6[10], 2022 (1991)Google Scholar
10. Burn, I., J. Mater. Sci., 14, 2453 (1979)Google Scholar
11. Kröger, F.A., and Vink, H. J., Solid State Phys., 3, 307 (1956)Google Scholar
12. Tsur, Y., and Randall, C. A., Submitted to J. Appl. Phys., (1999)Google Scholar
13. Maria, J. P., MS. Thesis, Penn. State Univ., (1996)Google Scholar
14. Hagemann, H. J., and Ihrig, H.., Phys. Rev., B20, 3871 (1979)Google Scholar
15. Albertsen, K., Hennings, D., and Steigelmann, O., J. Electoceramics 2, 3, 193 (1998)Google Scholar
16. Jaffe, B., Cook, W. R. Jr and Jaffe, H., Piezoelectric Ceramics, Academic Press Inc., (1971)Google Scholar