Hostname: page-component-7bb8b95d7b-w7rtg Total loading time: 0 Render date: 2024-09-10T15:25:33.201Z Has data issue: false hasContentIssue false
  • English
  • Français

Effects of matrix composition on instant release fractions from high burn-up nuclear fuel

Published online by Cambridge University Press:  23 January 2013

Olivia Roth ,
Jeanett Low ,
Michael Granfors  and
Kastriot Spahiu
Olivia Roth
Affiliation:
Studsvik Nuclear AB, Hot Cell Laboratory, SE-611 82 Nyköping, Sweden
Jeanett Low
Affiliation:
Studsvik Nuclear AB, Hot Cell Laboratory, SE-611 82 Nyköping, Sweden
Michael Granfors
Affiliation:
Studsvik Nuclear AB, Hot Cell Laboratory, SE-611 82 Nyköping, Sweden
Kastriot Spahiu
Affiliation:
SKB, Box 250, SE-101 24, Stockholm, Sweden.
Get access

Abstract

The release of radionuclides from spent nuclear fuel in contact with water is controlled by two processes – the dissolution of the UO2 grains and the rapid release of fission products segregated either to the gap between the fuel and the cladding or to the UO2 grain boundaries. The rapid release is often referred to as the Instant Release Fraction (IRF) and is of interest for the safety assessment of geological repositories for spent fuel due to the potential dose contribution.

Previous studies have shown that the instant release fraction can be correlated to the fission gas release (FGR) from the spent fuel. Studies comparing results from samples in the form of pellets, fragments, powders and a fuel rodlet have shown that the sample preparation has a significant impact on the instant release, indicating that the differentiation between gap release and grain boundary release should be further explored.

Today, there are trends towards power uprates, longer fuel cycles and increasing burn-up putting additional requirements on the nuclear fuel. These requirements are met by the development of new fuel types, such as UO2 fuels containing dopants or additives. The additives and dopants affect fuel properties such as grain size and fission gas release. In the present study we have performed experimental leaching studies using two high burnup fuels with and without additives/dopants and compared the fuel types with respect to their instant release behavior. The results of the leaching of the samples for the 3 initial contact periods; 1, 7 and 23 days are reported here.

Keywords

Ucorrosionnuclear materials
Type
Articles
Information
MRS Online Proceedings Library (OPL) , Volume 1518: Symposium LL – Scientific Basis for Nuclear Waste Management XXXVI , 2012 , pp. 145 - 150
Copyright
Copyright © Materials Research Society 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Johnson, L. H. and McGinnes, D. F., Nagra Technical Report NTB 02–07, (2002).Google Scholar
Johnson, L. H., Poinssot, C., Ferry, C. and Lovera, P., Nagra Technical Report NTB 04–08, (2004).Google Scholar
Johnson, L. H. and Tait, J. C., SKB TR 97–18, (1997).Google Scholar
Ferry, C., Piron, J-P., Poulesquen, A. and Poinssot, C., Mater. Res. Soc. Symp. Proc. 1107, 2008, pp. 447–454.CrossRefGoogle Scholar
Johnson, L. et al. ., J. Nucl. Mater., 420, 54–62 (2012).CrossRefGoogle Scholar
Zwicky, H-U., Low, J., Ekeroth, E., SKB TR 11–03, (2011).Google Scholar
Ekeroth, E. et al. . Mater. Res. Soc. Symp. Proc. 1475, paper O36 (2012).CrossRefGoogle Scholar
Kamimura, K.. IAEA-TECDOC-697, International Atomic Energy Agency, pp 82–88 (1992).Google Scholar
Backman, K. et al. ., in: IAEA-TECDOC-1654, pp. 117–126 (2010).Google Scholar
Izmer, A., Boulyga, S. F. and Becker, J. S., J. Anal. At. Spectrom. 18 1339–1345 (2003).CrossRefGoogle Scholar