Hostname: page-component-77c89778f8-m42fx Total loading time: 0 Render date: 2024-07-17T13:34:40.982Z Has data issue: false hasContentIssue false

Epitaxial CoSi2/Porous-Si Strained Layer Structres Grown by Mbe

Published online by Cambridge University Press:  28 February 2011

Y. C. Kao
Affiliation:
Device Research Laboratory, Electrical Engineering Department, University of California, Los Angeles, CA 90024
D. Jamieson
Affiliation:
California Institute of Technology, Pasadena, CA 91125
G. Bai
Affiliation:
California Institute of Technology, Pasadena, CA 91125
C. W. Nieh
Affiliation:
California Institute of Technology, Pasadena, CA 91125
T. L. Lin
Affiliation:
Device Research Laboratory, Electrical Engineering Department, University of California, Los Angeles, CA 90024 Now at: Jet Propulsion Laboratories, Pasadena, CA
B. J. Wu
Affiliation:
Device Research Laboratory, Electrical Engineering Department, University of California, Los Angeles, CA 90024
H. Y. Chen
Affiliation:
Device Research Laboratory, Electrical Engineering Department, University of California, Los Angeles, CA 90024
K. L. Wang
Affiliation:
Device Research Laboratory, Electrical Engineering Department, University of California, Los Angeles, CA 90024
Get access

Abstract

CoSi2 epitaxial layers with thickness ranging from 24 nm to 170 nm have been grown onto porous Si substrates by molecular beam epitaxy. The X-ray rocking curves and transmission electron microscopy (TEM) are used to examine the strain relaxation and interface quality. Backscattering with channeling is used to characterize the crystallinity of the epilayers. The results show that it is necessary to grow a thin buffer Si layer in order to improve the interfacial sharpness and crystallinity of the epilayers; near perfect crystallinity is then obtained as the thickness of the CoSi2 films exceed 50 nm. TEM results reveal that both CoSi2/Si and CoSi2/porous-Si interfaces are flat and layer thickness is uniform. It is found by TEM that the dislocation density of CoSi2 grown on porous Si is much lower than that on single-crystal Si. For thin CoSi2 grown on porous Si, the TEM and strain measurement results imply that part of the film is pseudomorphic where no dislocations are observed. Average strains of CoSi2 films grown on porous Si substrates with thicknesses greater than 30 nm show a lower strains comparing to that on crystalline Si. This suggests that by using porous Si as substrates the stress energy in the epilayer can be accommodated by the Si buffer layer that bridged over the trenches of porous Si.

Type
Research Article
Copyright
Copyright © Materials Research Society 1987

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Tang, R., Poate, J., Bean, J., Gibson, J., and Jacobson, D., Thin Solid Films, 93, 77 (1982).Google Scholar
2. Kao, Y. C., Tejwani, M., Xie, Y. H., Lin, T. L., and Wang, K. L., J. Vac. Sci. Technol., B3(2), 596 (1985).Google Scholar
3. Jamieson, D., Bai, G., Kao, Y. C., Nieh, C. W., Nicolet, M-A., and Wang, K. L., to be presented in Mat. Res. Soc. Spring meeting, 1987.Google Scholar
4. Luryi, S. and Suhir, E., Appl. Phys. Lett. 49, 140 (1986).Google Scholar
5. Ishizaka, A., Nakagawa, K., and Shiraki, Y., Proceeding of Conference on Molecular Beam Epitaxy and Clean surface Techniques (Japanese Society of Applied Physics, Tokyo, Japan, 1982), p. 183.Google Scholar
6. Unagami, T., Jpn, J. Appl. Phys. 19, 231 (1980).Google Scholar
7. Lin, T. L., Chen, S. C., Kao, Y. C., and Wang, K. L., Appl. Phys. Lett. 48, 1793 (1986);Google Scholar
Tabe, M., Jpn. J. Appl. Phys. 21, 534 (1982).Google Scholar
8. Speriosu, V. S., and Vreeland, T. Jr., J. Appl. Phys. 56, 1591 (1984).Google Scholar
9. Kao, Y. C., Wang, K. L., de Fresart, E., Hull, R., Bai, G., Jamieson, D., and Nicolet, M-A., J. Vac. Sci. Technol. (in press)Google Scholar