Hostname: page-component-77c89778f8-gvh9x Total loading time: 0 Render date: 2024-07-17T14:27:53.625Z Has data issue: false hasContentIssue false
  • English
  • Français

Failure Characteristics of Bilayer Lipid Membranes (BLMs) Formed over a Single Pore

Published online by Cambridge University Press:  01 February 2011

David Hopkinson  and
Donald J. Leo
David Hopkinson
Affiliation:
dph@vt.edu, Virginia Tech, Mechanical Engineering, 310 Durham Hall, Blacksburg, VA, 24061, United States, 540-231-2910, 540-231-2903
Donald J. Leo
Affiliation:
donleo@vt.edu, Virginia Tech, Mechanical Engineering, 310 Durham Hall, Blacksburg, VA, 24061, United States
Get access

Abstract

A new methodology has been developed to measure the maximum pressure that can be withstood by a bilayer lipid membrane (BLM) formed over porous substrates. A custom test fixture was fabricated to pressurize BLMs in very fine increasing increments until they fail. This experiment was performed on 1-Stearoyl-2-Oleoyl-sn-Glycero-3-Phosphatidylocholine (SOPC) BLMs formed over polycarbonate substrates with a single pore ranging from 5 to 20 microns in diameter. Failure pressure was found to be inversely proportional to pore diameter. The same set of experiments was repeated for BLMs that were formed from a mixture of SOPC and 50 mol% cholesterol (CHOL). The presence of cholesterol was found to increase the failure pressure of the BLMs by 56% on average. A model of the characteristic pressure curve from this experiment was developed based on the pressurization and flow of fluid through a porous substrate. The model was found to accurately fit the experimental pressure curves.

Keywords

biological synthesis (assembly)self-assemblystrength
Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 1061: Symposium MM – Biomolecular and Biologically Inspired Interfaces and Assemblies , 2007 , 1061-MM03-19
Copyright
Copyright © Materials Research Society 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Hamley, I. W., Introduction to Soft Matter, (Wiley, Chichester, England, 2005) pp. 193–265.Google Scholar
2. Sundaresan, V. B and Leo, D. J, J. Intel. Mat. Syst. Struct. 17, 863–870 (2006).Google Scholar
3. Mitchison, J. M and Swann, M. M, J. Exp. Biol. 31, 443–460 (1954).Google Scholar
4. Evans, E. and Needham, D., J. Phys. Chem. 91, 4219–4228 (1987).Google Scholar
5. Lim, C. T, Zhou, E. H, and Quek, S. T, J. Biomech. 39, 195–216 (2006).Google Scholar
6. Needham, D. and Nunn, R. S, Biophys. J. 58, 997–1009 (1990).Google Scholar
7. Bear, J., Dynamics of Fluids in Porous Media, (Elsevier, New York, 1972) pp. 119–136.Google Scholar
8. Adamson, A. W, Physical Chemistry of Surfaces, 5th ed., (Wiley, New York, 1990) pp. 4–10.Google Scholar
9. Hopkinson, D. and Leo, D. J, In Proc. SPIE Conf. Smart Struct. & Mat. 6526, (2007).Google Scholar