Hostname: page-component-5c6d5d7d68-pkt8n Total loading time: 0 Render date: 2024-08-17T23:12:40.905Z Has data issue: false hasContentIssue false

Measurements of the Surface Resistance of Hts Thin Films From 0.5 to 40Ghz

Published online by Cambridge University Press:  28 February 2011

J. Steinueck
Affiliation:
RADC/EEAC, Ilanscom AFB, MA 01731
D.E. Oates
Affiliation:
Lincoln Laboratory, Massachusetts Institute of Technology, Lexington, MA 02173
A.C. Anderson
Affiliation:
Lincoln Laboratory, Massachusetts Institute of Technology, Lexington, MA 02173
Get access

Abstract

We have measured the surface resistance R, in polycrystalline films of YBCO and BSCCO deposited in our laboratory as well as oriented films made by other laboratories by codepostion techniques. The R, of YBCO and BSCCO has been measured in the frequency range between 0.5 and 40 GHz using a stripline resonator technique. R, for the films is nearly proportional to the square of the applied frequency over the entire measurement range. The magnitude of R, is, however, strongly dependent on the film microstructure. Our measurements at 1 GHz and 4 K show that randomly oriented films have R, ~ 10~3 Ω (close to Cu) while oriented large-grain films have markedly lower R, ~ 2 x 10-6 Ω, approaching the R, of superconducting Nb. The magnitude of R, rises to ~ 2 Ω and ~ 10-3 Ω at 40 GHz for the randomly oriented and preferentially oriented films, respectively. An effective penetration depth, λeff, has been determined from R, using local electrodynamics. We find that λeff is dependent on film microstructure and is ~ 5 µm for high-R, films, decreasing to ~ 5000 Å for low-R, films. The smaller values of Ωeff calculated for oriented films are of similar magnitude to values of the YBCO penetration depth (~ 2000 Å) reported in the literature. The use of the stripline resonator technique for temperature and magnetic field dependent i Measurements of R, will also be discussed.

Type
Research Article
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Sridhar, S. and Kennedy, W.L., Rev. Sei. Inst. 59, 531 (1988).Google Scholar
2 Puller, W.W., Rachford, F.J., Lechter, W.L., Broussard, P.R., Allen, L.H., Claussen, J.H., IEEE Trans. Mag. 25, 2394 (1989).Google Scholar
3 Carini, J.P., Awasthi, A.M., Beyermann, W., Grüner, G., Hylton, T., Char, K., Beasley, M.R., and Kapitulnik, A., Phys. Rev. B 37, 9726 (1988).Google Scholar
4 Klein, N., Muller, G., Piel, H., Roas, B., Schultz, L., Klein, U., Peiniger, M., Appl. Phys Lett. 54, 757 (1989)Google Scholar
5 Korbin, P., Preparation and Materials Properties of High Temperature Superconductors, edited by Koch, R., Clarke, J., and Foner, S. (Elsevier Science Publishers, New York, 1989).Google Scholar
6 Dilorio, M.S., Anderson, A.C., and Tsaur, B.-Y., Phys. Rev. B 38, 7019 (1988).Google Scholar
7 Mankiewich, P.M., Scofield, J.H., Skocpol, W.J., Howard, R.E., Dayem, A.H., and Good, E., Appl. Phys. Lett. 51, 1753 (1989)Google Scholar
8 Greer, J.A., Proceedings of the Third Annual Conference on Superconductivity and Applications, Buffalo, N.Y. Sept. 1989 (to be published).Google Scholar
9 Steinbeck, J., Tsaur, B.-Y., Anderson, A.C., and Strauss, A.J., Appl. Phys. Lett. 54, 466 (1989).Google Scholar
10 Anlage, S.M., Langley, B., Halbritter, J., Tahara, S., Sze, H., Switz, N., Enom, C.B., Snortland, H.J., Taber, R., Geballe, T.H., and Beasley, M.R., Appl. Phys. Lett. (1989).Google Scholar
11 Sunshine, S.A., Siegrist, T., Schneemeyer, L.F., Murphy, D.W., Cava, R.J., Batlogg, B., Van Dover, R.B., Flemming, R.M., Glarum, S.H., Nakahara, S., Farrow, R., Krajewski, J.J., Zahurak, S.M., Waszczak, J.V., Marshall, J.H., and Peck, W.F., Phys. Rev. B 38, 893 (1988).Google Scholar
12 Hylton, T. and Beasley, M.R., Phys. Rev. B 39, 9042 (1989).Google Scholar
13 Halbritter, J. (to be published).Google Scholar