Hostname: page-component-84b7d79bbc-c654p Total loading time: 0 Render date: 2024-07-26T23:17:13.342Z Has data issue: false hasContentIssue false
  • English
  • Français

Microstructure and Mechanical Behavior of Magnetron Sputtered Al-Cu Films

Published online by Cambridge University Press:  26 February 2011

Tsann Lin  and
V. Raman
Tsann Lin
Affiliation:
IBM Corporation, Storage Systems Products Division San Jose, CA 95193
V. Raman
Affiliation:
IBM Corporation, Storage Systems Products Division San Jose, CA 95193
Get access

Abstract

We have investigated the microstructure, electrical resistivity and mechanical behavior of DC magnetron sputtered A1-4wt%Cu films. The substrate temperatures were varied systematically from room temperature to 500 °C. Scanning and transmission electron microscopy of the sputtered films show that the top surface of the films sputtered at low temperatures (< 200 °C) exhibits a pure Al-like fine grain morphology. In contrast, sputter deposition at higher temperatures (> 300 °C) produces films that are characterized at the top surface by a distribution of θ’-A12Cu precipitates with a platelet morphology. The mechanical behavior of the sputtered films were investigated by performing indentation tests using a depth-sensing technique.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 226: Symposium H – Mechanical Behavior of Materials and Structures in Microelectronics , 1991 , 203
Copyright
Copyright © Materials Research Society 1991

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Fraser, D.B., Thin Film Processes, (edited by Vossen, J.L. and Kern, W. ), p. 115, Academic Press, New York (1978).Google Scholar
2. Smith, F., Zold, F. T. and Class, W., Thin Solid Films 96, 291 (1982) 2).Google Scholar
3. Skelly, D. W. and Gruenke, L. A., J. Vac. Sci. Technol. 4, 457 (1986).Google Scholar
4. Lin, T., Ahn, K. Y., Harper, J. M. E and Chaloux, P., Proc. VMIC Conf. p. 76, 1988.Google Scholar
5. Pethica, J., Hutchings, R. and Oliver, W.C., Phil. Mag. A48, 593 (1983).Google Scholar
6. Doerner, M.F. and Nix, W.D.,.J. Mater. Res. 1, 601 (1986).Google Scholar
7. Hannula, P., Stone, D. and Li, C-Y, Electronic Packaging Materials Science, edited by Giess, E.A., Tu, K.-N. and Uhlimann, D.R. ( Mater. Res. Soc. Proc. 40, Pittsburgh, Pa 1985 ) pp. 217–224.Google Scholar
8. Lin, T., Ahn, K. Y., Harper, J. M. E, Madakson, P. B. and Fryer, P. M., Thin Solid Films, 154, 81 (1987).Google Scholar
9. Raman, V. and Berriche, R. Thin Films: Stresses and Mechanical Properties, edited by Doerner, M.F., Oliver, W., Pharr, G.M. and Brotzen, F.R. (Mater. Res. Soc. Proc. 188, Pittsburgh, Pa 1990 ) pp. 171–176.Google Scholar