Hostname: page-component-77c89778f8-vpsfw Total loading time: 0 Render date: 2024-07-16T16:56:23.705Z Has data issue: false hasContentIssue false
  • English
  • Français

Microwave Polymerization of Embedding Resins for Biological/Biomedical Elecron Microscopy

Published online by Cambridge University Press:  28 February 2011

B.L. Giammara ,
D.J. Birch  and
D.O. Harper
B.L. Giammara
Affiliation:
Graduate Programs and Research, Univ. of Louisville, Louisville, KY 40292
D.J. Birch
Affiliation:
Graduate Programs and Research, Univ. of Louisville, Louisville, KY 40292
D.O. Harper
Affiliation:
Department of Chemical Engineering, Univ. of Louisville, Louisville, KY 40292
Get access

Abstract

The use of microwave energies for polymerization of epoxy and other commercially available resins, used routinely in electron microscopy methodologies, shows promise for diagnostic pathology where rapid methods can be crucial. Many desirable embedment properties, such as specimen infiltration, color, hardness, rough trimming, and ability to stain, are necesssary. The properties necessary for cutting 1 micron semithin sections and 700 Angstrom ultrathin sections (that can withstand pentration by a 100 kV electron beam for image formation) must be maintained.

In this study, six epoxy resins and one unsaturated polyester resin were used, the latter in a variety of recipes. Each formulation was subjected to microwave power levels from 400 to 700 W for 1 to 15 minutes. Selected specimen embedments tested well and significantly reduced traditional convection oven polymerization time from two days to a few minutes.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 189: Symposium L – Microwave Processing of Materials II , 1990 , 347
Copyright
Copyright © Materials Research Society 1991

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Walker, J., Sci. Amer., 256 (2), 134–138 (1987).Google Scholar
2. Giammara, B., Proc. 43rd Ann. Meet. Elect. Micros. Soc. Am. San Francisco, CA, pp. 706–707, (1985).Google Scholar
3. Luft, J., J. Biophys. Biochem. Cytol., 9, 409–414 (1961).Google Scholar
4. “Castin' Craft Clear: Liquid Plastic Casting Resin”, (E. T. I., P. O. Box 365, Fields Landing, CA 95537).Google Scholar
5. Giammara, B., Ed., Elect. Micros. Soc. Am. (Technologist's Forum): Education Committee. (Univ. of Louisville, Louisville, KY (1985).Google Scholar
6. Shroff, M. H., Thesis, M. S., Univ. of Louisville, 1988.Google Scholar
7. Glauert, A.. Fixation, Dehydration, and Embedding of Biological Specimens. (North-Holland Publ. Co., Amsterdam, (1974).Google Scholar