Hostname: page-component-77c89778f8-gvh9x Total loading time: 0 Render date: 2024-07-23T06:25:37.594Z Has data issue: false hasContentIssue false
  • English
  • Français

Reactive Infiltration Processing of Bulk and Fiber-Reinforced NiAl

Published online by Cambridge University Press:  15 February 2011

T. A. Venkatesh ,
C. W. Sanmarchi ,
A. Mortensen  and
D. C. Dunand
T. A. Venkatesh
Affiliation:
Department of Materials Science and Engineering, Massachusetts Institute of Technology, Cambridge, MA 02139
C. W. Sanmarchi
Affiliation:
Department of Materials Science and Engineering, Massachusetts Institute of Technology, Cambridge, MA 02139
A. Mortensen
Affiliation:
Department of Materials Science and Engineering, Massachusetts Institute of Technology, Cambridge, MA 02139
D. C. Dunand
Affiliation:
Department of Materials Science and Engineering, Massachusetts Institute of Technology, Cambridge, MA 02139
Get access

Abstract

Reactive infiltration processing was investigated in the NiAl system using nickel-powder and nickel-wire preforms. Inhomogeneous microstructures were often obtained with powder preforms which had high surface-to-volume ratio, low permeability and irregular infiltration paths. Homogenous NiAl could be obtained with nickel-wire preforms which had lower surface-to-volume ratio, higher permeability and regular infiltration paths. NiAl composites reinforced with short molybdenum fibers and long tungsten and sapphire fibers were also fabricated by reactive infiltration.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 460: Symposium Z – High-Temperature Ordered Intermetallic Alloys VII , 1996 , 737
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Noebe, R.D., Bowman, R.R., and Nathal, M.V., Inter. Mater. Rev. 38, 193 (1993).Google Scholar
2. Miracle, D.B., Acta Metall, et Mater. 41, 649 (1993).Google Scholar
3. Dimiduk, D.B., Miracle, D.B., and Ward, C.H., Materials Science and Technology 8, 367 (1992).Google Scholar
4. Dunand, D.C., Materials and Manufacturing Processes 10, 373 (1995).Google Scholar
5. Dunmead, S.D., Munir, Z.A., Holt, J.B., and Kingman, D.D., J. Mat. Sci. 26, 29 (1991).Google Scholar
6. Dunand, D.C., Sommer, J.L., and Mortensen, A., Metall. and Mater. Trans. 24A, 2161 (1993).Google Scholar
7. Kubachewski, O., in Ternary Alloys - A Comprehensive Compendium of Evaluated Constitutional Data and Phase Diagrams, edited by Petzow, G. and Effenberg, G. (1993) p. 208.Google Scholar
8. Alkaseeva, Z. M., Ternary Alloys - A Comprehensive Compendium of Evaluated Constitutional Data and Phase Diagrams, edited by Petzow, G. and Effenberg, G. (1993) p. 54.Google Scholar
9. Venkatesh, T.A. and Dunand, D.C., in Deformation and Fracture of Ordered Intermetallic Materials, edited by Soboyejo, W.O., Srivatsan, T.S., and Fraser, H.L., (TMS, Warrandale, PA 1996), in press.Google Scholar