Hostname: page-component-78c5997874-t5tsf Total loading time: 0 Render date: 2024-11-19T11:56:30.134Z Has data issue: false hasContentIssue false

Silicon-Carbon Alloys Synthesized by Electron Cyclotron Resonance Chemical Vapor Deposition

Published online by Cambridge University Press:  17 March 2011

Mark B. Moran
Affiliation:
Research and Engineering, Code 4T4110D, Naval Air Warfare Center, China Lake, CA 93555
Linda F. Johnson
Affiliation:
Research and Engineering, Code 4T4110D, Naval Air Warfare Center, China Lake, CA 93555
Get access

Abstract

Silicon-carbon alloys were deposited by electron cyclotron resonance chemical vapor deposition (ECR-CVD) using either halogenated or non-halogenated precursors for the Si and C sources. Halogenated precursors were chosen for initial experiments to try to reduce the H content and to improve the microstructure of the silicon carbide (SiCx) films. While a wide range of compositions has been deposited using the halogenated precursors, only a limited range has been deposited so far with the non-halogenated precursors. Electron spectroscopy for chemical analysis (ESCA) and Fourier transform infrared (FTIR) spectroscopy show that compositions ranging from near-stoichiometric SiCx to extremely C-rich can be deposited by controlling the deposition temperature, plasma power and C/Si ratio of the halogenated precursors. At the highest C/Si-precursor ratio, the deposited film is electrically conductive with a measured resistivity of 0.067ω-cm, contains only 3-atomic-percent Si and should be considered a Si-doped carbon (C:Si) film. The excellent transparency, especially that of the C:Si films, allowed the assignment of FTIR absorption bands that are usually masked by graphitic inclusions and other impurities. A weak absorption band at 1180cm−1 was found to correlate with the electrical conductivity of the films and was attributed to the asymmetric “bond-and-a-half” Si=C stretch in a Si=C=C functional group where the pi electrons are distributed equally between the three atoms. Additional results show etching of the substrate by reactive Cl from the halogenated precursors can have a dramatic effect on the microstructure, porosity and moisture stability of the films. For experiments involving halogenated precursors, the C:Si films are much more stable than the near-stoichiometric SiCx because C:Si is deposited at lower plasma powers that do not etch the Si substrate. Finally, preliminary results show that near-stoichiometric SiCx films deposited using non-halogenated precursors are much more stable with respect to moisture incorporation than those deposited with halogenated precursors.

Type
Research Article
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Shimkunas, A. R., Mauger, P. E., Bourget, L. P., Post, R. S., Smith, L., Davis, R. F., Wells, G. M., Cerrina, F. and McIntosh, R. B., J. Vac. Sci. Technol., B 9 (6), 32583261 (1991).Google Scholar
2. Moran, M. B. and Johnson, L. F., Mat. Res. Soc. Symp. Proc., 555, 353364 (1999).Google Scholar
3. Spitzer, W. G., Kleinman, D. A., Frosch, C. J. and Walsh, D. J., in Silicon Carbide: A High Temperature Semiconductor, ed. O'Connor, and Smiltens, (Pergamon, 1960), pp. 347365.Google Scholar
4. Lehmann, A., L. Schumann and Hubner, K., Phys. Stat. Sol. (b), 121, 505 (1984)..Google Scholar