Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-23T23:00:33.224Z Has data issue: false hasContentIssue false

Characterization of nano-crystalline structure of TiO2 for Dye-sensitized Solar Cells by Raman spectroscopy and spectroscopic ellipsometry

Published online by Cambridge University Press:  25 July 2013

Sergey Mamedov
Affiliation:
HORIBA Scientific, M, NJ 08820, USA
Takumi Moriyama
Affiliation:
HORIBA, Ltd., Kyoto, Japan
Tomoko Numata
Affiliation:
HORIBA, Ltd., Kyoto, Japan
Nataliya Nabatova-Gabain
Affiliation:
HORIBA, Ltd., Kyoto, Japan
Shozo Yanagida
Affiliation:
Center for Advanced Science and Innovation (CASI), Osaka University, Japan
Li Yan
Affiliation:
HORIBA Scientific, M, NJ 08820, USA
Get access

Abstract

Dye-sensitized solar cells (DSSCs) are attractive alternatives to conventional solid-state photovoltaic devices because of performance, stability, environmental compatibility and cost. In contrast to the conventional systems where the semiconductor assumes both the task of light absorption and charge carrier transport, these two functions are separate in DSSC and, therefore, efficiency is very sensitive to the cell structure/composition. High-efficiency DSCs based on mesoporous nanocrystalline titanium dioxide (TiO2) electrodes have received considerable research attention in the past decade. Grain size and thickness of the mesoporous TiO2 film have shown a dominant effect on the efficiency of the photovoltaic devices.

We have investigated screen printed TiO2 films deposited on a textured fluorinated SnO2 (FTO) glass substrate, using Raman spectroscopy and spectroscopic ellipsometry. Materials were prepared by repeating a same screen-printing procedure once, twice and three times, using TiO2 paste with 10nm, 20 nm and 200nm particles sequentially. Raman spectra of PV devices cells taken at different excitation (266 nm, 325 nm, 364 nm, 532 nm, 633 nm, and 1064 nm) as well as pure TiO2 oxides are presented. Different excitation wavelengths allow to probe different depth of the sample. It was found that there is strong correlation of the position and the width of E2g mode of anatase at 144 cm-1 and size of TiO2 particles. The samples show that this peak shifts to the high frequency region and becomes broader for small size particles. The position and broadening of the peak can be described by optical confinement model that depends on the size of nano-crystals. Results showed varying grain sizes as correlated with different TiO2 paste applied. Thickness, optical constants and porosity of TiO2 films were determined by spectroscopic ellipsometry. In this work, we have demonstrated the use of Raman Spectroscopy and Spectroscopic Ellipsometry for non-destructive characterization of nanocrystalline TiO2 films for dye-sensitized solar cells.

Type
Articles
Copyright
Copyright © Materials Research Society 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Zhu, K.R. et al. , Physics Letter A, 340, 220 (2005)CrossRefGoogle Scholar
Gupta, Sanjeev K. et al. , J.Raman Spectr. 41, 350 (2010).Google Scholar
Tanemura, S. et al. Applied Surface Sci, 212 654 (2003).CrossRefGoogle Scholar