Hostname: page-component-848d4c4894-tn8tq Total loading time: 0 Render date: 2024-06-26T18:26:17.227Z Has data issue: false hasContentIssue false
  • English
  • Français

The Effect of Grown-In Point Defects on Sb Diffusion in MBE-Grown Si and Sige

Published online by Cambridge University Press:  10 February 2011

J.M. Bonar ,
B.M. Mcgregor ,
A.F.W. Willoughby  and
A.D.N. Paine
J.M. Bonar
Affiliation:
Department of Electronics and Computer Science, University of Southampton, Southampton. SO17 lBJ UIk. jbuecs.soton.ac.uk
B.M. Mcgregor
Affiliation:
Department of Engineering Materials. University of Southampton, Southampton, S017 1B.J. UK
A.F.W. Willoughby
Affiliation:
Department of Engineering Materials. University of Southampton, Southampton, S017 1B.J. UK
A.D.N. Paine
Affiliation:
Department of Engineering Materials. University of Southampton, Southampton, S017 1B.J. UK
Get access

Abstract

The diffusion of antimony in Si and SiGe under the influence of grown-in point defects is studied in this work. The layers were grown by very low temperature MBE, and the diffused profiles measured using SIMS analysis. Fast diffusion of Sb is observed in both Si and SiGe. and is thought to be caused by grown-in point defects, specifically vacancies, arising from the very low temperature MIBE growth. The vacancies may be removed by heat treatments. and it was found that the processing the samples received before the heat treatments caused the most substantial diffusion. Comparison of the diffusivities for inert diffusion at 850°C following the heat treatments suggests 30 minutes at 800°C is sufficient to remove the majority of the grown-in defects. The diffusion of Sb in Si is thus demonstrated to be a very sensitive monitor of grown-in vacancies, and dopants which diffuse at least partly by vacancy mediated processes would be expected to be affected by this effect.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 568: Symposium S – Silicon Front-End Processing-Physics & Technology of Dopant… , 1999 , 103
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Chen, W. M., Buyanova, I. A. and Monemar, B., Mater. Res. Soc. Proc. 442, Pittsburgh, PA (1997) 355–365.Google Scholar
[2] Labrie, D., Aers, G. C., Lafontaine, H., Williams, R. L., Charbonneau, S., Goldberg, R. D. and Mitchell, L. V., Appl. Phys. Lett. 69 (25) 3866–3868 (1996).Google Scholar
[3] Paine, A. D. N., Willoughby, A. F. W., Morooka, M., Bonar, J. M., Phillips, P., Dowsett, M. G. and Cooke, G., in Defect and Diffusion Forum 143–147 (Part II) 1131–1134 (1997).Google Scholar
[4] Paine, A. D. N., Willoughby, A. F. W. and Bonar, J. M., J Mater. Sci. Mater. in Elec. accepted for publication, expected 1999.Google Scholar
[5] Fahey, P., Iyer, S. S. and Scilla, G. J., Appl. Phys. Lett. 54 (9) 843–845 (1989).Google Scholar
[6] Hayafuji, Y., Kajiwara, I. and Usui, S., J. Appl. Phys. 53 (12) 8639–8646 (1982).Google Scholar
[7] Larsen, A. N. and Kringhol, P., Appl. Phys. Lett. 68 (19) 2684–2686 (1996).Google Scholar