Hostname: page-component-7479d7b7d-qlrfm Total loading time: 0 Render date: 2024-07-13T11:15:02.063Z Has data issue: false hasContentIssue false
  • English
  • Français

Influences of Hydrogen on the Evolution of the Electrical Resistivity Of Ultra-Thin Sputtered Copper Films Measured in Real-Time

Published online by Cambridge University Press:  01 February 2011

E. V. Barnat ,
P. -I. Wang ,
D. Nagakura  and
T. -M. Lu
E. V. Barnat
Affiliation:
Department of Physics, Applied Physics and Astronomy and The Center for Integrated Electronics and Electronics Manufacturing (CIEEM), Rensselaer Polytechnic Institute, Troy, NY 12180-3590, USA
P. -I. Wang
Affiliation:
Department of Physics, Applied Physics and Astronomy and The Center for Integrated Electronics and Electronics Manufacturing (CIEEM), Rensselaer Polytechnic Institute, Troy, NY 12180-3590, USA
D. Nagakura
Affiliation:
Department of Physics, Applied Physics and Astronomy and The Center for Integrated Electronics and Electronics Manufacturing (CIEEM), Rensselaer Polytechnic Institute, Troy, NY 12180-3590, USA
T. -M. Lu
Affiliation:
Department of Physics, Applied Physics and Astronomy and The Center for Integrated Electronics and Electronics Manufacturing (CIEEM), Rensselaer Polytechnic Institute, Troy, NY 12180-3590, USA
Get access

Abstract

The electrical resistivities of copper films sputtered in either argon or an argon-hydrogen atmosphere are measured in real time, during growth. The electrical resistivities for both cases are observed to be functions of the film's thickness, with the films grown in the hydrogen containing atmosphere possessing a resistivity of 4.5 +/- 0.2 μΩ-cm at 40 nm, lower than the resistivity of 5.0 +/-0.3 μΩ-cm for 40 nm thick films grown in the argon atmosphere. Furthermore, the electrical resistivities for both sets of films were observed to continue to evolve after the termination of deposition. The amount of change and the rate of change were observed to depend on the film's thickness as well as atmosphere the films were grown in. Measurements made by X-ray diffraction (XRD) and transmission electron microscopy (TEM) indicate that the presence of hydrogen also influences the preferential crystallographic orientation as well as grain size distribution. These measurements indicate that the differences in the microstructure are correlated to the observed differences in the behavior of the electrical resistivities.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 721: Symposia E/J – Texture and Microstructure in Electronic and Magnetic Films – Nanostructural Magnetic Materials for Data Storage , 2002 , J3.6
Copyright
Copyright © Materials Research Society 2002

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Kuan, T. S., Inoki, C. K., Oehlein, G. S., Rose, K., Zhao, Y. -P., Wang, G. -C., Rossnagel, S. M., and Cabral, C., Mat. Res. Soc. Sym. Proc. 612, D71.1 (2000).Google Scholar
2. Liu, H. -D., Zhao, Y. -P., Ramanath, G., Murarka, S. P., and Wang, G. -C., Thin Solid Films 384, 151 (2001).Google Scholar
3. Barnat, E. V., Nagakura, D., Wang, P. -I., and Lu, T.-M, J. Appl. Phys. 91, 1667 (2002).Google Scholar
4. Mallikarjunan, A., Sharma, S., and Murarka, S.P., Electrochemical and Solid-State Letters 3, 437.Google Scholar
5. Barnat, E.V. and Lu, T. -M., submitted to Review of Scientific Instruments Google Scholar
6. Thompson, C. V., Annu. Rev. Mater. Sci. 20, 245 (1990).Google Scholar
7. Rodbell, K.P., Ph.D. Thesis, Rensselaer Polytechnic Institute, Troy NY (1986).Google Scholar
8. Rodbell, K.P., Ficalora, P.J. J. of Appl. Phys. 65, 3107 (1986).Google Scholar
9. Miyake, T., Petek, H, Takeda, K. and Hinode, K., Appl. Phys. Lett. 70, 1239 (1997).Google Scholar
10. Harper, J. M. E., Cabral, C., Andricacos, P. C., Gignac, L., Noyan, I. C., Rodbell, K. P., and Hu, C. K., J. Appl. Phys. 86, 2516 (1999).Google Scholar