Article contents
Optimization of Dielectric Cap Adhesion to Ultra-Low-k Dielectrics
Published online by Cambridge University Press: 17 March 2011
Abstract
In this work, the adhesion of CVD dielectric caps to ULK MSQ spin-on dielectric materials with k values of 2.2 and 2.0, and a ULK CVD material with a k value of 2.7 is presented. A substantial improvement in cap adhesion to both the k2.2 ULK MSQ and the k2.7 ULK CVD material is demonstrated. The improvement is obtained using a low-k CVD glue material between the ULK dielectric and the subsequent cap material and/or by optimizing the CVD cap film deposition. Four-point bend measurement of adhesion strength is used to quantify the improvement in interface adhesion. The improvement in CVD cap adhesion is demonstrated to be strongly dependent upon both the glue layer film and the cap deposition conditions. While optimization of the CVD cap materials results in adequate adhesion for the k2.2 ULK MSQ, these improvements are demonstrated not to extend to the k2.0 ULK MSQ film.
- Type
- Research Article
- Information
- Copyright
- Copyright © Materials Research Society 2004
References
- 2
- Cited by