Hostname: page-component-7bb8b95d7b-nptnm Total loading time: 0 Render date: 2024-09-12T14:10:01.335Z Has data issue: false hasContentIssue false
  • English
  • Français

The Use of a Hot-Wire Anemometer in Turbulent Flow

Published online by Cambridge University Press:  04 July 2016

B. J. Hoole  and
J. R. Calvert
B. J. Hoole
Affiliation:
Engineering Department, University of Cambridge
J. R. Calvert
Affiliation:
Engineering Department, University of Cambridge
Get access Rights & Permissions [Opens in a new window]

Extract

The hot-wire anemometer is one of the few instruments which can be used to make velocity measurements in turbulent and unsteady flows. However, the probe supporting the wire inevitably interferes with the local flow and it has been found that the effect of this interference on the reading of the anemometer varies considerably as the orientation of the probe to the flow direction is changed (the wire itself being maintained in the same direction). This leads to errors in any measurements taken where the instantaneous local flow direction differs significantly at any time from the direction for which the anemometer was calibrated. Such errors are quite separate from, and in addition to, errors due to finite wire length, incidence of the wire to the local stream direction, etc.

Type
Technical Notes
Information
The Aeronautical Journal , Volume 71 , Issue 679 , July 1967 , pp. 511 - 513
Copyright
Copyright © Royal Aeronautical Society 1967

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1.Kovasznay, L. S. G.Hot-Wire Investigation of the Wake behind Cylinders at Low Reynolds Numbers. Proc Roy SocA, Vol 198, p 174, 1949.Google Scholar
2.Berger, E. Die Bestimmung der hydrodynamischen Größen einer Karmanschen Wirbelstraße aus Hitzdrahtmessungen bei kleinen Reynoldsschen Zahlen. Zeitschrift für Flugwissenschaften, February 1964.Google Scholar
3.Webster, C. A. G.A Note on the Sensitivity to Yaw of a Hot-Wire Anemometer. J Fl Mech, Vol 13, p 307, 1962.Google Scholar