Hostname: page-component-78c5997874-dh8gc Total loading time: 0 Render date: 2024-11-19T11:37:48.900Z Has data issue: false hasContentIssue false
  • English
  • Français

The use of bonded crack-stoppers in pressure cabins

Published online by Cambridge University Press:  04 July 2016

Mark Norris
Get access Rights & Permissions [Opens in a new window]

Extract

The memory of the early Comet tragedies lives on as a reminder that aircraft structures must be damage tolerant. Aircraft structures may be cracked in manufacture or in service as a result of fatigue, corrosion, incorrect maintenance, the impact of ground handling equipment or accidents such as a turbine disc break-up. A damage tolerant structure should retain adequate residual strength until any cracks are detected and repaired.

Type
Research Article
Information
The Aeronautical Journal , Volume 85 , Issue 841 , February 1981 , pp. 57 - 62
Copyright
Copyright © Royal Aeronautical Society 1981 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

References

1. Kuchemann, D. The aerodynamic design of aircraft.Google Scholar
2.Propagation of fatigue cracks in wide unstiffened aluminium alloy sheets. RAE Tech Note Structures No 305, September 1961.Google Scholar
3. Virkler, D. A. et al. The statistical nature of fatigue crack propagation. ASME Journal of Engineering Materials and Technology, Vol 101, April 1979.Google Scholar
4. Cartwright, D. J. and Rich, T. P. Plastic strip yielding for a crack in a stiffened sheet.Google Scholar
5. Coleman, M. A. Pressure cabin damage tolerance — relative efficiencies of crack-stoppers. Hatfield Polytechnic, 1978.Google Scholar
6. Anderson, J. M. et al. Growth characteristics of a fatigue crack approaching and growing beneath an adhesively bonded doubler. ASME Journal of Engineering Materials and Technology, Vol 100, No 1.Google Scholar

Bibliography

A general introduction to fracture mechanics. Mech Eng Pubs Ltd, 1978, Transactions of ASME, Journal of Engineering Materials and Technology, Vol 100, No 1. Eleven papers on structural integrity of bonded structures.Google Scholar
Joint Airworthiness Requirements Document 125.Google Scholar
Pressure cabin design — comparative European and AmericanGoogle Scholar
practice. D. Eccles. BAe-QRS-R GEN-0061. British Aerospace AG HQ.Google Scholar
Bonded strips as crackstoppers for pressure cabins. E. M. Norris, Department of Aeronautics and Astronautics, Southampton University, 1979.Google Scholar