Hostname: page-component-84b7d79bbc-lrf7s Total loading time: 0 Render date: 2024-07-29T21:14:23.790Z Has data issue: false hasContentIssue false
  • English
  • Français

Geotechnical properties and behaviour of the Monasavu halloysite clay, Fiji

Published online by Cambridge University Press:  09 July 2018

D. J. Knight
D. J. Knight*
Affiliation:
Geotechnical Engineering, Sir Alexander Gibb & Partners, Earley House, London Road, Earley, Reading RG6 1BL
Get access Rights & Permissions [Opens in a new window]

Abstract

Geotechnical properties and behaviour are described of the very wet, halloysitic, residual clay found in the dense rain forest at Monasavu, Viti Levu, Fiji, where the annual rainfall can exceed 5 m. The tropical climatic conditions have caused deep weathering of sandstones and produced a highly plastic clay with low density and a natural moisture content greatly in excess of the standard compaction optimum. This clay was found to contain halloysite which was ‘amorphous’ rather than crystalline. The material was used in this natural state in an 85-m high rockfill dam at Monasavu Falls as an unusually soft core, the construction of which involved unconventionally light compaction by low-ground-pressure-tracked dozers. Its resulting behaviour in terms of three-dimensional total and effective stresses, stress paths and deformations throughout the construction, impounding and full reservoir stages was closely monitored. This behaviour is examined in the light of the clay's classification, mineralogical, compaction and engineering properties determined before and during construction. Despite its unusual properties, it is concluded that the clay is a good engineering material, behaving like others containing halloysite in the more common tubular form, and, moreover, that the high natural moisture content is of positive benefit.

Type
Research Article
Information
Clay Minerals , Volume 21 , Issue 3 , September 1986 , pp. 311 - 332
Copyright
Copyright © The Mineralogical Society of Great Britain and Ireland 1986

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

The Australian Mineral Development Laboratories (1979) Clay mineralogy of six soil samples. Unpublished Report GS Q4797/79for Sir Alexander Gibb & Partners Australia, 22nd June 1979. Google Scholar
Eggleton, A. (1981) Fiji clay investigation. Unpublished Report for Sir Alexander Gibb & Partners Australia, 15th July 1981, The Australian National University, Canberra, ACT. Google Scholar
Frost, R.J. (1967) Importance of correct pretesting preparation of some tropical soils. Proc. 1st Southeast Asian Regional Conference on Soil Engineering, Bangkok, 43–53.Google Scholar
Knight, D.J., Worner, N.M. & McClung, J.E. (1982) Materials and construction methods for a very wet clay core rockfill dam at Monasavu Falls, Fiji. Proc. 14th Int. Cong. on Large Dams, Rio de Janeiro, 4, 293–303.Google Scholar
Knight, D.J. (1982) Discussion, question 55: Materials and construction methods for embankment dams and cofferdams—testing methods and quality control. Proc. 14th Int. Congr. on Large Dams, Rio de Janeiro, 5, 598–604.Google Scholar
Knight, D.J. (1984) Monasavu Dam in Fiji. Introductory note, ICE/BNCOLD, London, March 1984, 1-6. Also discussion paper, ‘Monasavu Dam, Fiji’. BNCOLD News and Views, 27, 12–13.Google Scholar
Knight, D.J., Naylor, D.J. & Davis, P.D. (1985) Stress-strain behaviour of the Monasavu soft core rockfill dam: prediction, performance and analysis. Proc. 15th Int. Congr. on Large Dams, Lausanne, 1, 1299–1326.Google Scholar
Sherard, J.L. (1981) Building embankment dams in areas of high rainfall. Syrup. on hydro-electric development in the Amazon Region, São Paulo, Brazil. Google Scholar
Slansky, E. (1978) Clay mineral analysis of two specimens from Fiji (for Longworth and McKenzie Pty Ltd). Geological Survey Report No. GS 1978/153 (unpublished). Geological Survey of New South Wales, Department of Mines. Google Scholar
Teazaghi, K. (1958) Design and performance of the Sasumua Dam. Proc. Inst. Civil Engineers 9, 369–394.Google Scholar
Vauohan, P.R. (1982) Design and construction with wet fills. Special Lecture to Associacão Brasileira de Mecãnica dos Solos, São Paulo, April 1982. Google Scholar
Wesley, L.D. (1973) Some basic engineering properties of halloysite and allophane clays in Java, Indonesia. Geotechnique 23, 471–494.Google Scholar