Hostname: page-component-586b7cd67f-dsjbd Total loading time: 0 Render date: 2024-11-29T08:08:24.876Z Has data issue: false hasContentIssue false
  • English
  • Français

A model heat-exchange apparatus for the investigation of fouling of stainless steel surfaces by milk I. Deposit formation at 100 °C

Published online by Cambridge University Press:  01 June 2009

Carole L. Foster ,
Michel Britten  and
Margaret L. Green
Carole L. Foster
Affiliation:
AFRC Institute of Food Research, Reading Laboratory, Shinfield, Reading RG2 9AT, UK
Michel Britten
Affiliation:
Groupe de Recherche STELA, Département de Sciences et Technologie des Aliments, Université Laval, Québec, CanadaG1K 7P4
Margaret L. Green
Affiliation:
AFRC Institute of Food Research, Reading Laboratory, Shinfield, Reading RG2 9AT, UK
Get access Rights & Permissions [Opens in a new window]

Summary

A model heat-exchange apparatus was used to investigate the factors affecting deposit formation from milk on a stainless steel surface at 100 °C. The structure and composition of the deposits were determined by scanning electron microscopy, energy-dispersive X-ray spectroscopy, and chemical analysis after solution in alkali. The effects of changing the pH, preheating and skimming of the milk were similar to those observed in a small-scale continuous ultra high temperature plant. The time course of deposit formation showed that a lag phase did not occur, but the deposit which formed after more than 45 min was more porous than that formed after shorter times. Most (50–90%) of the fresh deposit was readily removed by sonication, leaving a sublayer richer in minerais than the original. The results provide evidence for the two-layer model for deposit formation proposed by Tissier & Lalande (1986).

Type
Original Articles
Information
Journal of Dairy Research , Volume 56 , Issue 2 , May 1989 , pp. 201 - 209
Copyright
Copyright © Proprietors of Journal of Dairy Research 1989

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Al-Roubaie, S. M. A., Burton, H. & Skudder, P. J. 1981 The effect of surface tension on the deposition of solids from milk on heated surfaces. In Fouling of Heat Transfer Equipment pp. 477–482 (Eds Somerscales, E. F. C. and Knudsen, J. G.). Washington: Hemisphere Publishing Corp.Google Scholar
Baier, R. E. 1981 Modification of surfaces to reduce fouling and/or improve cleaning. In Fundamentals and Applications of Surface Phenomena Associated with Fouling and Cleaning in Food, Processing pp. 168–189 (Eds Hallström, B., Lund, D. B. and Trägårdh, Ch.). Lund, Sweden: Lund University Division of Food EngineeringGoogle Scholar
Britten, M., Green, M. L., Boulet, M. & Paquin, P. 1988 Deposit formation on heated surfaces: effect of interface energetics. Journal of Dairy Research 55 551–562CrossRefGoogle Scholar
Burton, H. 1961 A laboratory method for the investigation of milk deposits on heat exchange surfaces. Journal of Dairy Research 28 255–263Google Scholar
Burton, H. 1965 A method for studying the factors in milk which influence the deposition of milk solids on a heated surface. Journal of Dairy Research 32 65–78Google Scholar
Burton, H. 1966 A comparison between a hot-wire laboratory apparatus and a plate heat exehanger for determining the sensitivity of milk to deposit formation. Journal of Dairy Research 33 317–324Google Scholar
Burton, H. 1967 Seasonal variation in deposit formation from whole milk on a heated surface. Journal of Dairy Research 34 137–143Google Scholar
Burton, H. 1968 Reviews of the progress of Dairy Science. Section G. Deposits from whole milk in heat treatment plant – a review and discussion. Journal of Dairy Research 35 317–330Google Scholar
Lalande, M., Tissier, J.-P. & Corrieu, G. 1984 Fouling of a plate heat exchanger used in ultra-high-temperature sterilization of milk. Journal of Dairy Research 51 557–568CrossRefGoogle Scholar
Lang, C. A. 1958 Simple mierodetermination of Kjeldahl nitrogen in biological materials. Analytical Chemistry 30, 1692–1694CrossRefGoogle Scholar
Lyster, R. L. J. 1965 The composition of milk deposits in an ultra-high-temperature plant. Journal of Dairy Research 32 203–208Google Scholar
Simonsen, D. G., Wertman, M., Westover, L. M. & Mehl, J. W. 1946 The determination of serum phosphate by the molybdivanadate method. Journal of Riological Chemistry 166 747–755Google ScholarPubMed
Skudder, P. J. 1981 a The role of sulphydryl groups in the formation of proteinaceous deposit from milk on heated surfaces. In Fundamentals and Applications of Surface Phenomena Associated with Fouling and Cleaning in Food Processing pp. 378–387 (Eds Hallström, B., Lund, D. B. and Trägårdh, Ch.). Lund, Sweden: Lund University Division of Food EngineeringGoogle Scholar
Skudder, P. J. 1981 b Effects of adding potassium iodate to milk before UHT treatment. II Iodate-induced proteolysis during subsequent aseptic storage. Journal of Dairy Research 48 115–122Google Scholar
Skudder, P. J., Brooker, B. E., Bonsey, A. D. & Alvarez-Guerrero, N. R. 1986 Effect of pH on the formation of deposit from milk on heated surfaces during ultra high temperature processing. Journal of Dairy Research 53 75–87Google Scholar
Skudder, P. J., Thomas, E. L., Pavey, J. A. & Perkin, A. G. 1981 Effeets of adding potassium iodate to milk before UHT treatment. I. Reduction in the amount of deposit on the heated surfaces. Journal of Dairy Research 48 99–113Google Scholar
Tissier, J. P. & Lalande, M. 1986 Experimental device and methods for studying milk deposit formation on heat exchange surfaces. Biotechnology Progress 2 218–229Google Scholar