Published online by Cambridge University Press: 20 October 2017
The effect of initial conditions on transition to turbulence is studied in a variable-density shock-driven flow. Richtmyer–Meshkov instability (RMI) evolution of fluid interfaces with two different imposed initial perturbations is observed before and after interaction with a second shock reflected from the end wall of a shock tube (reshock). The first perturbation is a predominantly single-mode long-wavelength interface which is formed by inclining the entire tube to 80$^{\circ }$ relative to the horizontal, yielding an amplitude-to-wavelength ratio, $\unicode[STIX]{x1D702}/\unicode[STIX]{x1D706}=0.088$, and thus can be considered as half the wavelength of a triangular wave. The second interface is multi-mode, and contains additional shorter-wavelength perturbations due to the imposition of shear and buoyancy on the inclined perturbation of the first case. In both cases, the interface consists of a nitrogen-acetone mixture as the light gas over carbon dioxide as the heavy gas (Atwood number, $A\sim 0.22$) and the shock Mach number is $M\approx 1.55$. The initial condition was characterized through Proper Orthogonal Decomposition and density energy spectra from a large set of initial condition images. The evolving density and velocity fields are measured simultaneously using planar laser-induced fluorescence (PLIF) and particle image velocimetry (PIV) techniques. Density, velocity, and density–velocity cross-statistics are calculated using ensemble averaging to investigate the effects of additional modes on the mixing and turbulence quantities. The density and velocity data show that a distinct memory of the initial conditions is maintained in the flow before interaction with reshock. After reshock, the influence of the long-wavelength inclined perturbation present in both initial conditions is still apparent, but the distinction between the two cases becomes less evident as smaller scales are present even in the single-mode case. Several methods are used to calculate the Reynolds number and turbulence length scales, which indicate a transition to a more turbulent state after reshock. Further evidence of transition to turbulence after reshock is observed in the velocity and density fluctuation spectra, where a scaling close to $k^{-5/3}$ is observed for almost one decade, and in the enstrophy fluctuation spectra, where a scaling close to $k^{1/3}$ is observed for a similar range. Also, based on normalized cross correlation spectra, local isotropy is reached at lower wave numbers in the multi-mode case compared with the single-mode case before reshock. By breakdown of large scales to small scales after reshock, rapid decay can be observed in cross-correlation spectra in both cases.
These two authors contributed equally.
To send this article to your Kindle, first ensure no-reply@cambridge.org is added to your Approved Personal Document E-mail List under your Personal Document Settings on the Manage Your Content and Devices page of your Amazon account. Then enter the ‘name’ part of your Kindle email address below. Find out more about sending to your Kindle. Find out more about saving to your Kindle.
Note you can select to save to either the @free.kindle.com or @kindle.com variations. ‘@free.kindle.com’ emails are free but can only be saved to your device when it is connected to wi-fi. ‘@kindle.com’ emails can be delivered even when you are not connected to wi-fi, but note that service fees apply.
Find out more about the Kindle Personal Document Service.
To save this article to your Dropbox account, please select one or more formats and confirm that you agree to abide by our usage policies. If this is the first time you used this feature, you will be asked to authorise Cambridge Core to connect with your Dropbox account. Find out more about saving content to Dropbox.
To save this article to your Google Drive account, please select one or more formats and confirm that you agree to abide by our usage policies. If this is the first time you used this feature, you will be asked to authorise Cambridge Core to connect with your Google Drive account. Find out more about saving content to Google Drive.