Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-25T20:42:02.490Z Has data issue: false hasContentIssue false
  • English
  • Français

Effect of the Substrate on Microindentation Behavior

Published online by Cambridge University Press:  15 February 2011

T.J. Lardner ,
J.E. Ritter  and
H.B. Karamustafa
T.J. Lardner
Affiliation:
University of Massachusetts at Amherst
J.E. Ritter
Affiliation:
University of Massachusetts at Amherst
H.B. Karamustafa
Affiliation:
University of Massachusetts at Amherst
Get access

Abstract

A continuous microindentation apparatus was constructed with a maximum load capacity of 45 N (resolution of 0.1 N) and with a maximum displacement of 500 μm (resolution of 2.0 μm) and used to test bulk materials (brass, aluminum, steel, soda-lime glass and PMMA) and epoxy coatings on substrates of aluminum, steel, soda-lime glass and PMMA. The hardness (H) was determined with a Vickers indenter and compared to that obtained with a Tukon hardness tester. The elastic modulus of the coated systems was also estimated from the unloading curves. In general, we found that the indentation behavior of the epoxy coated system was influenced by the substrate with softer substrates (as with PMMA) being deformed before the indenter penetrates the coating. With all coated systems, the on-load value of H was independent of the penetration depth until the indenter penetrated the substrate. For the aluminum, steel and soda-lime glass substrates, the value of H after penetration increased slowly due to the pile up of the epoxy coating underneath the indenter supporting more of the load. For the PMMA substrate, hardness decreased after penetration because the hardness of PMMA was less than the epoxy coating.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 308: Symposium M1 – Thin Films: Stresses and Mechanical Properties IV , 1993 , 189
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 FABES, B.D., Oliver, W.C., McKee, R.A., and Walker, F.J., J. Mater. Res., 7 (11), 3056–3064 (1992).Google Scholar
2 LIN, M.R., Ritter, J.E., Rosenfeld, L., and Lardner, T.J., J. Mater. Res., 5 (5), 1110–1117 (1990).Google Scholar
3 PHARR, G.M, and Cook, R.F., J. Mater. Res., 5 (4), 847–851 (1990).Google Scholar
4 RITTER, J.E., Lardner, T.J., Madsen, D.T., and Giovinazzo, R.J., submitted for publication, J. Mater. Res., 1993.Google Scholar
5 OLIVER, W.C., and Pharr, G.M., J. Mater. Res., 7 (6) , 1564–1583 (1992).Google Scholar
6 RITTER, J.E., Sioui, D.R., and Lardner, T.J., Polymer Eng. and Science, 32 (18), 1366–1371 (1992).Google Scholar