Article contents
Silicon Carbon Alloys Produced by VHF and Conventional PECVD. A Comparison of their Properties.
Published online by Cambridge University Press: 16 February 2011
Abstract
The Very High Frequency (70 MHz) PECVD has recently proven its ability to produce Amorphous silicon with high deposition rates (10 Å/s) without affecting the quality of the Material. A comparative study of the optoelectronic properties of undoped silicon carbon alloys produced by Very High Frequency and by conventional RF (13.56 MHz) is carried out. Conductivity, infrared absorption, optical transmission and deep defect densities via PDS and ESR have been Measured. Deposition parameters under study aie methane fraction and hydrogen dilution. In contrast to conventional PECVD, we observe for VHF depositions an increase of the deposition rate with the addition of Methane. Larger energy gap and smaller Urbach energy values seem to indicate a better incorporation of carbon in the VHF case. A study of the degradation induced by light is also presented.
- Type
- Research Article
- Information
- Copyright
- Copyright © Materials Research Society 1994
References
REFERENCES
- 4
- Cited by