Hostname: page-component-78c5997874-mlc7c Total loading time: 0 Render date: 2024-11-19T12:00:58.814Z Has data issue: false hasContentIssue false
  • English
  • Français

Carbon Fiber Composite Molecular Sieves for Gas Separation

Published online by Cambridge University Press:  15 February 2011

M. Jagtoyen ,
F. Derbyshire ,
N. Brubaker ,
Y. Q. Fel ,
G. Kimber ,
M. Matheny  and
T. Burchell
M. Jagtoyen
Affiliation:
University of Kentucky Center for Applied Energy Research, 3572 Iron Works Pike, Lexington KY 40511-8433, USA
F. Derbyshire
Affiliation:
University of Kentucky Center for Applied Energy Research, 3572 Iron Works Pike, Lexington KY 40511-8433, USA
N. Brubaker
Affiliation:
University of Kentucky Center for Applied Energy Research, 3572 Iron Works Pike, Lexington KY 40511-8433, USA
Y. Q. Fel
Affiliation:
University of Kentucky Center for Applied Energy Research, 3572 Iron Works Pike, Lexington KY 40511-8433, USA
G. Kimber
Affiliation:
University of Kentucky Center for Applied Energy Research, 3572 Iron Works Pike, Lexington KY 40511-8433, USA
M. Matheny
Affiliation:
University of Kentucky Center for Applied Energy Research, 3572 Iron Works Pike, Lexington KY 40511-8433, USA
T. Burchell
Affiliation:
Oak Ridge National Laboratory, PO Box 2008, Oak Ridge, TN 37831-6088, USA
Get access

Introduction

Carbon fibers are produced commercially from rayon, phenolics, polyacrylonitrile (PAN), or pitch. The last are further divided into fibers produced from isotropic pitch precursors, and those derived from pitch that has been pretreated to introduce a high concentration of carbonaceous mesophase. Over the past few decades, interest in research and manufacturing carbon fibers has overwhelmingly centered on producing fibers with high tensile strength and high modulus for lightweight, high performance composites, where polymers, metals, and carbon can form the continuous matrix. The fibers most commonly used in advanced materials are produced from PAN or mesophase pitch. Graphitized mesophase pitch fibers tend to have higher modulus and lower tensile strength than the PAN-based equivalents. They have advantages in applications requiring high stiffness, high electrical and thermal conductivity, low thermal expansion, and high temperature oxidation resistance, while PAN fibers are employed where high strength is required.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 344: Symposium I – Materials and Processes for Environmental Protection , 1994 , 77
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Okuda, K., Petrotech, 5(1), 37 (1982).Google Scholar
2. Matsumura, Y., Seikiyu Gakaishi, 30(5), 291 (1987).Google Scholar
3. Thwaites, M. W., Stewart, M. L., McNeese, B. E., and Sumner, M., Fuel Proc.Tech., 34, 137–145 (1993).Google Scholar
4. Okuda, K., TANSO, 155, 426 (1992).Google Scholar
5. Soroushian, P., Aouadi, F. and Nagi, M., ACI Materials Journal, 88, No. 1, p. 11–18 (1991).Google Scholar
6. Derbyshire, F., Jagtoyen, M., Fei, Y. Q. and Kimber, G., Am. Chem. Soc., Div. Fuel Chem. Preprint, 39(1), 113–120 (1994).Google Scholar
7. Suzuki, M., Proc. Biennial Carbon Conference, Buffalo (1993).Google Scholar
8. Mochida, I., Sun, Y-N., Fijitsu, H., Kisamori, S., and Kawano, S., Nippon Kagaku Kaishi (J.Chemical Society of Japan), 6, 885–890 (1991).Google Scholar
9. Mochida, I., Hirayama, T., Kisamori, S., Kawano, S., and Fijitsu, H., Langmuir, 8 (9), 2290–94 (1992).Google Scholar
10. Foster, K. L., Fuerman, R. G., Economy, J., Larson, S. M., and J.Rood, M., Chem. Mater., 4, 1068–1073 (1992).Google Scholar
11. Economy, J., Foster, K., Andreopoulos, A., and Jung, H., Chemtech, 597–603, October (1992).Google Scholar
12. Suzuki, M., Water Science technology, 23, 1649 (1991).Google Scholar
13. Wei, G. C., and Robbins, J. M., Ceramic Bull., 64(5), 691–699 (1985).Google Scholar
14. Fei, Y.Q., Derbyshire, F., Jagtoyen, M. and Mochida, I., Eastern Oil Shale Symposium, Lexington, KY, USA, 17–19 November (1993).Google Scholar