Hostname: page-component-7dd5485656-hw7sx Total loading time: 0 Render date: 2025-10-31T14:47:02.764Z Has data issue: false hasContentIssue false
  • English
  • Français

Design of a current converter to maximize the power into homogeneous dielectric barrier discharge (DBD) devices

Published online by Cambridge University Press:  08 October 2013

Xavier Bonnin ,
Hubert Piquet ,
Nicolas Naudé ,
Mohamed Chérif Bouzidi ,
Nicolas Gherardi  and
Jean-Marc Blaquière
Xavier Bonnin*
Affiliation:
Université de Toulouse; INPT, UPS; LAPLACE (Laboratoire Plasma et Conversion d’Energie); ENSEEIHT, 2 rue Charles Camichel, BP 7122, 31071 Toulouse cedex 7, France CNRS; LAPLACE, 31071 Toulouse, France
Hubert Piquet
Affiliation:
Université de Toulouse; INPT, UPS; LAPLACE (Laboratoire Plasma et Conversion d’Energie); ENSEEIHT, 2 rue Charles Camichel, BP 7122, 31071 Toulouse cedex 7, France CNRS; LAPLACE, 31071 Toulouse, France
Nicolas Naudé
Affiliation:
Université de Toulouse; INPT, UPS; LAPLACE (Laboratoire Plasma et Conversion d’Energie); ENSEEIHT, 2 rue Charles Camichel, BP 7122, 31071 Toulouse cedex 7, France CNRS; LAPLACE, 31071 Toulouse, France
Mohamed Chérif Bouzidi
Affiliation:
Université de Toulouse; INPT, UPS; LAPLACE (Laboratoire Plasma et Conversion d’Energie); ENSEEIHT, 2 rue Charles Camichel, BP 7122, 31071 Toulouse cedex 7, France CNRS; LAPLACE, 31071 Toulouse, France
Nicolas Gherardi
Affiliation:
Université de Toulouse; INPT, UPS; LAPLACE (Laboratoire Plasma et Conversion d’Energie); ENSEEIHT, 2 rue Charles Camichel, BP 7122, 31071 Toulouse cedex 7, France CNRS; LAPLACE, 31071 Toulouse, France
Jean-Marc Blaquière
Affiliation:
Université de Toulouse; INPT, UPS; LAPLACE (Laboratoire Plasma et Conversion d’Energie); ENSEEIHT, 2 rue Charles Camichel, BP 7122, 31071 Toulouse cedex 7, France CNRS; LAPLACE, 31071 Toulouse, France
*
a e-mail: xavier.bonnin@laplace.univ-tlse.fr
Get access

Abstract

This paper proposes a design approach of an electrical power supply intended to offer an especially well-suited supply mode, through the efficient control of the current injected into a DBD setup. The proposed topology is aimed at controlling the operating point of the electrical discharge, thereby allowing favoring the homogeneous regime, and maximizing the electrical power injected into the plasma. The power supply structure is designed on the basis of causality criteria and of an analytical analysis of the electrical waveforms, which are derived from an equivalent circuit model of the DBD. Design issues of this electrical generator are detailed and experimental analysis of its operation, together with actual performances are presented. A very good agreement is obtained by comparing simulation and experiments. Effective ability to control the power transfers by means of its two degrees of freedom (current magnitude and frequency) is highlighted.

Information

Type
Research Article
Information
The European Physical Journal - Applied Physics , Volume 64 , Issue 1 , October 2013 , 10901
Copyright
© EDP Sciences, 2013

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Article purchase

Temporarily unavailable

References

Kogelschatz, U., Plasma Chem. Plasma Proc. 23, 1 (2003)CrossRef
Massines, F., Rabehi, A., Decomps, P., Gadri, R.B., Ségur, P., Mayoux, C., J. Appl. Phys. 83, 2950 (1998)CrossRef
Massines, F., Gherardi, N., Naudé, N., Ségur, P., Eur. Phys. J. Appl. Phys. 47, 22805 (2009)CrossRef
Massines, F., Gouda, G., Gherardi, N., Duran, M., Croquesel, E., Plasma. Polym. 6, 35 (2001)CrossRef
Seeböck, R., Esrom, H., Charbonnier, M., Romand, M., Kogelschatz, U., Proceedings of the 7th International Conference on Plasma Surface Engineering, Surf. Coat. Technol. 142–144, 455 (2001)CrossRefGoogle Scholar
Zhang, C., Shao, T., Long, K., Yu, Y., Wang, J., Zhang, D., Yan, P., Zhou, Y., IEEE Trans. Plasma Sci. 38, 1517 (2010)CrossRef
Vezzu, G., Lopez, J.L., Freilich, A., Becker, K.H., IEEE Trans. Plasma Sci. 37, 890 (2009)CrossRef
Lomaev, M., Sosnin, E., Tarasenko, V., Shits, D., Skakun, V., Erofeev, M., Lisenko, A., Instrum. Exp. Tech. 49, 595 (2006)CrossRef
Naudé, N., Cambronne, J.-P., Gherardi, N., Massines, F., J. Phys. D: Appl. Phys. 38, 530 (2005)CrossRef
Vongphouthone, S., Piquet, H., Foch, H., Eur. Phys. J. Appl. Phys. 15, 123 (2001)CrossRef
Diéz, R., Piquet, H., Cousineau, M., Bhosle, S., IEEE Trans. Ind. Electron. 59, 1912 (2012)CrossRef
Diéz, R., Salanne, J.P., Piquet, H., Bhosle, S., Zissis, G., Eur. Phys. J. Appl. Phys. 37, 307 (2007)CrossRef
Raizer, Y.P., Gas Discharge Physics (Springer Verlag, Berlin, 1991)CrossRefGoogle Scholar
Bonnin, X., Master’s thesis, INP Toulouse, ENSEEIHT, 2011
Cousineau, M., Díez, R., Piquet, H., Durrieu, O., IEEE Trans. Ind. Electron. 59, 1920 (2012)CrossRef
Basso, C. and ON-Semiconductor, Application note AND8029/D Ramp Compensation for NCP1200, Technical report, ON Semiconductor, 2001Google Scholar
Bonnin, X., Piquet, H., Florez, D., Diez, R., Designing the high voltage transformer of power supplies for dbd: windings arrangment to reduce the parasitic capacitive effects, in European conference on Power Electronics (EPE), 2013Google Scholar