Studies of long-term seismic activity in any region of the world require the longest historical perspective as possible. In most of the regions of Europe, before the XIIIth and the XIVth centuries, historical sources allow to establish a catalogue of felt earthquakes but the available data give very few information to estimate local intensities and epicentres.

Thus, the knowledge of the seismic activity begins really at this epoch and covers a time period of less than 700 years. From that time, sources from different origins. (chronicles, annotations, parish registers, account registers,…) give us more details on local effects and allow reliable estimation of damages and perceptibility area of the earthquakes. It is then possible to determine the probable epicentral area of the strongest earthquakes and also to estimate their magnitude by comparison with recent earthquakes for which the magnitude has been instrumentally determined.

The Late weichselian Pleniglacial wind regime in the eastern Netherlands is reconstructed by means of landform and sedimentological analysis. This analysis involves aeolian and fluvial landforms in the Dinkel river valley in the Twente region. The aeolian deposits considered here date from the Last Glacial Maximum (approximately 22 ka) to the start of the Belling Interstadial at 14.7 ka.

A major event in this period is the formation of a cryoturbation level caused by permafrost degradation, overlain by an erosional hiatus dated between 21 and 17 ka. Both features are attributed to a period of warmer and moister climate, causing permafrost degradation and erosion by surficial runoff. Thereafter aeolian activity prevailed under relatively arid conditions. A deflation surface was formed, the Beuningen Gravel Bed. This deflation surface is present in many Weichselian sections in the Netherlands and the adjacent parts of Belgium and Germany. The deflation occurred concurrently with deposition of coversand at other places.

The morphology of the coversand-landscape in the Dinkel valley was controlled by the relief of the pre-existing floodplain and the wind pattern. Coversand ridges consisting of low dunes accumulated near the margins of the active channel belt. Relatively thick sand sheets occur in the leesides of the ridges, thin sand sheets are found at greater distance.

Mainly westerly sand-transporting winds operated during winter and summer. In winter aeolian deposition occurred by frequent and strong easterly winds also. On the smallest, local scale, the pattern of deposition was determined by the topography and moisture of the receiving surface.

Coversand deposition came to an end with the formation of a sand sheet under relatively warm and less arid conditions. Coversand deposition continued into the Belling Interstadial; colonization of the coversand surface by vegetation probably has been delayed by nutrient-poor conditions.

The shift from the coldYounger Dryas phase to the relatively warm Pre-boreal at~l 1.5 thousand years BP occurred within 50 calendar years and represents a clear example of rapid climate warming. Geologists and palaeo-ecologists have extensively studied the impact of this shift on the environment in The Netherlands. The global atmospheric general circulation model of the Max-Planck-Institute for Meteorology is applied to perform simulations of the Younger Dryas and Pre-boreal climates. Here detailed results are presented for the grid-cell representing The Netherlands, providing quantified estimates of climatic means and extremes for both periods. The results suggest that the Younger Dryas climate was characterised by cold winters (temperatures regularly below -20 °C) and cool summers (13-14 °C), with a high inter-annual variability, strong fluctuations in temperature, frequent storms and snowfall from September to May. The Pre-boreal climate was a ‘continental’ version of present-day climate, with cooler winters, warmer summers (~2 °C difference) and more snowfall, but lower wind speeds. Also, the Pre-boreal climate was wetter than the present and Younger Dryas climates. The main driving factors were the low temperatures of the partly sea-ice covered N Atlantic Ocean and the insolation that was very different from today, with more incoming solar radiation during summer (+30W/m2) and less during winter (-10W/m2).The presented detailed results could be valuable for interpreting palaeo-environmental records and for modelling studies on sedimentological processes during the Late Quaternary.

The Bree Uplift is a particular structure in the direct footwall of the southwestern graben boundary fault system of the Roer Valley Graben, which has been firstly recognized at the base of the Cretaceous. To date fault activity around the Bree Uplift has been confined to the Subhercynian (late Cretaceous) inversion event or considered fading out during Tertiary times.

The revision of the existing geological data reveals that the Bree Uplift can still be recognized on the top-Tertiary map. This infers at least a late Tertiary activity, suggesting continuous fault activity in the graben boundary fault system not only on the major boundary faults but also on different splay faults, bounding individual fault blocks.

A high-resolution reflection seismic survey was carried out in 1999 over the Feldbiss fault system, the southern border of the Roer Valley graben, in Belgium. Six profile-lines with total length of 13982 m provided information on the 40-600 m depth range, covering Lower Pleistocene to Miocene strata with special emphasis on the Plio-Pleistocene Kieseloolite formation. Data quality depends on near-surface conditions and on degree of deformation in some fault zones, with better results for seismic detonator sources compared to vibroseis sources. The new data confirm the segmented character of the fault system with occurrence of fault bends, relay ramps and branching of overlapping fault sequences, testifying of the strong tectonic activity during the lower Pleistocene. Antiform structures along the Bichterweerd scarp, relaying the Feldbiss to the Geleen fault in the Meuse valley, are presented as a model for the Tertiary evolution of the Bree Uplift.

The 35.5 m thick Anisian section of theWinterswijkse Steen- en Kalkgroeve (Eastern Netherlands) comprises the Upper Röt (Upper Röt Claystone Member) to the basal Lower Muschelkalk (Oolith Member). In the section 15 terrestrial or marine influenced parasequences are recognized. A fourth order sequence shows the increasing marine influence. New marker beds, ten vertebrate track beds, three bone beds and cephalopod remains have been documented. This enabled correlation to other sections in NW Germany. The tracks found in the Winterswijkse Steen- en Kalkgroeve at the boundary Röt/Lower Muschelkalk are linked to the oldest known vertebrate skeleton remains of the Germanic Basin. It is the first time that the exact stratigraphic position of these vertebrate remains has been established. In the terrestrial influenced section of the Winterswijkse Steen- en Kalkgroeve, the well preserved vertebrate track ways and vertebrate fauna will be of international importance and will provide new data of theTriassic carbonate tidal flat megatracksite concept and reptiles living in this environment.

This paper describes the Raman and infrared spectroscopy of SrSO4 or celestine from the Muschelkalk of Winterswijk, The Netherlands. The infrared absorption spectrum is characterised by the SO42-modes V1 at 991 cm-1, v3 at 1201, 1138 and 1091 cm-1, and v4 at 643 and 611 cm-1. An unidentified band is observed at 1248 cm-1. In the Raman spectrum at 293 K the V1 mode is found at 1000 cm-1 and is split in two bands at 1001 and 1003 cm-1 upon cooling to 77 K.The v2 mode, not observed in the infrared spectrum, is observed as a doublet at 460 and 453 cm-1. The v3 mode is represented by four bands in the Raman spectrum at 1187, 1158, 1110 and 1093 cm-1 and the v4 mode as three bands at 656, 638 and 620 cm-1. Cooling to 77 K results in a general decrease in bandwidth and a minor shift in frequencies. A decrease in intensities is observed upon cooling to 77 K due to movement of the Sr atom towards one or more of the oxygen atoms in the sulfate group.

We studied the applicability of classical scarp degradation modelling to active normal faults in the Lower Rhine Embayment. Our quantitative analysis was conducted on the frontal Bree fault scarp (Feldbiss fault) in Belgium and the Peel fault scarp near the city of Neer in the Netherlands. Vertical offset and diffusion age of these scarps have been modelled from elevation profiles across the studied faults using the diffusion equation. For that purpose, a computer-program (profil 2000) has been written, providing a sensitivity analysis of the determined parameters in function of the spatial repartition of the elevation measurements along the considered profiles. The results of this morphometric analysis have been validated by a comparison with the geologic record of the tectonic activity observed in the trenches excavated at the sites where the measurements have been conducted.

We conclude that the modelling can only be applied to study tectonic activity since the Last Glacial Maximum (±14-19 kyr BP) because the surface expression of older paleoearthquakes in unconsolidated Late Pleistocene sediments has been erased by the strong erosive phase that occurred at the end of this glacial period. Even for Holocene scarps, morphologic dating seems very difficult because man-made perturbations destroyed surface evidence of the very recent fault activity in many sites. Nevertheless, we estimate that an appropriate value for the mass diffusivity constant for~ 1-m-high scarps in the investigated region is 0.002 to 0.010 m2/yr. On the other hand, vertical offsets can be determined with a good precision. These amount to respectively ~1 m and 1,3 m since the Last Glacial Maximum on the Feldbiss fault in Belgium and the Peel fault near Roermond in the Netherlands.

To evaluate correlations between silt and clay fractions determined by pipette method and laser diffraction, samples from Dutch fine marine, fluvial, and loess deposits were analysed by both methods. For fluvial deposits, correlations for fractions <2 and >50 μm were excellent (R2 > 0.95), those for 2–4, 4–8, 16–32 and 32–50 μm were satisfactory (R2 = 0.80 – 0.95), while that for the fraction 8–16 μm had an R2 of only 0.68. For marine deposits, correlations for <2 and >50 μm were in the same range, but those of all other fractions except 8–16 μm were lower. In the loess samples, correlations for all but the 8–16 μm fraction were unsatisfactory. Laser diffraction gave 42% of pipette clay in marine samples, and 62% in fluvial and loess samples if regressions are forced through 0. Sand fractions detected by laser diffraction were 107% of the sieve fraction in marine samples, and 99% in the fluvial samples. Correlations for fractions smaller than reference size are generally better than those for individual size fractions. Both the 2 μm and the 50 μm boundary cause problems in the comparison. The first because of platy shape of clay minerals, and the second due to both a change in method in the pipette/sieving procedure, and to non-sphericity of particles. Apparently, correlations for clay- and silt-size fractions obtained by pipette method and laser diffraction will be different for each type of sediment.

Topographic and morphologic models based on detailed Digital Elevation Models (DEM) of the Rur Graben, in particular a 33 km section of the Rurrand Fault, proved to be essential in preliminary investigations for the site selection of a trench for detailed paleoseismological investigations. The entire DEM in the 33 km Jülich-Düren area displayed as a color-shaded terrain map clearly illustrates the main features of the eastern border fault of the Rur Graben. As investigations concentrated on the 8x6 km Stetternich-Hambach section of the Rurrand fault, the use of contoured topographic, gray-shaded terrain and terrain slope maps helped delineate the main features of the surface fault expression. On the basis of topographic profiles constructed from the DEM, no fault scarp could be identified; however, the detailed surveying results from two geophysical profiles correlated well with the topographic data.

In preparation of the first paleoseismic trenching in the NE border of the Roer graben (the Netherlands), site selection was carried out. Combining geological and seismological information and using existing aerial photographs, seismic reflection and geodetic levelling data, it was decided to focus on the Peel boundary fault near the village of Neer. Detailed information on the exact location of the fault was obtained through geophysical techniques, mainly ground penetrating radar (GPR) and resistivity measurements. GPR data unambiguously showed the flexuring and offset of reflectors affected by the fault. Performing eleven GPR profiles along strike allowed to obtain a 3D picture of the fault, laterally extending the information given in the trench.