Crossref Citations
This Book has been
cited by the following publications. This list is generated based on data provided by Crossref.
Chow, J.H.
Zhong, Z.W.
Lin, W.
and
Khoo, L.P.
2012.
A study of thermal deformation in the carriage of a permanent magnet direct drive linear motor stage.
Applied Thermal Engineering,
Vol. 48,
Issue. ,
p.
89.
Zeng, Yang
and
Katsuta, Masafumi
2012.
Numerical Simulation of Heat Flow in a Vehicle Cabin.
Advanced Materials Research,
Vol. 602-604,
Issue. ,
p.
1769.
Zeng, Yang
Katsuta, Masafumi
and
Anamizu, Tomohiro
2013.
Numerical Simulation of Heat Flow in a Vehicle Cabin Using the Personal Air Conditioning System.
Advanced Materials Research,
Vol. 694-697,
Issue. ,
p.
755.
Pike-Wilson, E.A.
and
Karayiannis, T.G.
2014.
Flow boiling of R245fa in 1.1 mm diameter stainless steel, brass and copper tubes.
Experimental Thermal and Fluid Science,
Vol. 59,
Issue. ,
p.
166.
Faraji, Amir Yadollah
Singh, Randeep
Mochizuki, Masataka
and
Akbarzadeh, Aliakbar
2014.
Design and Numerical Simulation of a Symbiotic Thermoelectric Power Generation System Fed by a Low-Grade Heat Source.
Journal of Electronic Materials,
Vol. 43,
Issue. 6,
p.
1940.
Terrani, Kurt A.
Pint, Bruce A.
Parish, Chad M.
Silva, Chinthaka M.
Snead, Lance L.
Katoh, Yutai
and
Jacobson, N.
2014.
Silicon Carbide Oxidation in Steam up to 2 MPa.
Journal of the American Ceramic Society,
Vol. 97,
Issue. 8,
p.
2331.
Ramachandran, P. A.
2014.
Advanced Transport Phenomena.
Yang, Patricia J.
Pham, Jonathan
Choo, Jerome
and
Hu, David L.
2014.
Duration of urination does not change with body size.
Proceedings of the National Academy of Sciences,
Vol. 111,
Issue. 33,
p.
11932.
Wang, Xin
Li, Wenbin
Xu, Weilin
and
Wang, Hao
2014.
Study on the surface temperature of fabric in the process of dynamic moisture liberation.
Fibers and Polymers,
Vol. 15,
Issue. 11,
p.
2437.
Dippel, Moritz
and
Grünewald, Marcus
2015.
Produktschonende Betriebs‐ und Designparameter von Wärmeübertragern für temperaturempfindliche Prozessströme.
Chemie Ingenieur Technik,
Vol. 87,
Issue. 12,
p.
1833.
Amiri, Ahmad
Kazi, S. N.
Shanbedi, Mehdi
Mohd Zubir, Mohd Nashrul
Yarmand, Hooman
and
Chew, B. T.
2015.
Transformer oil based multi-walled carbon nanotube–hexylamine coolant with optimized electrical, thermal and rheological enhancements.
RSC Advances,
Vol. 5,
Issue. 130,
p.
107222.
Wu, Yaoxing
Eichler, Clara M. A.
Chen, Shengyang
and
Little, John C.
2016.
Simple Method To Measure the Vapor Pressure of Phthalates and Their Alternatives.
Environmental Science & Technology,
Vol. 50,
Issue. 18,
p.
10082.
Ghiaasiaan, S. Mostafa
2017.
Handbook of Thermal Science and Engineering.
p.
1.
Nasirabadi, Parizad Shojaee
and
Hattel, Jesper H.
2017.
A numerical investigation of the effect of ambient conditions on natural convection cooling of electronics.
p.
1.
Ghahfarokhi, Payam Shams
Kallaste, Ants
Vaimann, Toomas
Rassolkin, Anton
and
Belahcen, Anouar
2017.
Determination of forced convection coefficient over a flat side of coil.
p.
1.
Qin, Longhui
Hu, Liang
Mao, Kai
Chen, Wenyu
and
Fu, Xin
2017.
Flowrate Determination for Arbitrary Multipath Arrangement Based on Generalized Inverse of Matrix.
IEEE Sensors Journal,
Vol. 17,
Issue. 12,
p.
3625.
Chiba, Younes
2017.
Experimental and Numerical Study of the Behavior of a Multilayer for Active Magnetic Refrigerator Based on La-Fe-Co-Si.
IEEE Transactions on Magnetics,
Vol. 53,
Issue. 11,
p.
1.
Tisovská, Petra
Peukert, Pavel
Kolář, Jan
and
Dančová, P.
2017.
Verification of ANSYS Fluent and OpenFOAM CFD platforms for prediction of impact flow.
EPJ Web of Conferences,
Vol. 143,
Issue. ,
p.
02130.
Ghiaasiaan, S. Mostafa
2017.
Two-Phase Flow, Boiling, and Condensation.
Wang, Wenhao
Wu, Fuzhong
and
Jin, Huixin
2017.
Enhancement and performance evaluation for heat transfer of air cooling zone for reduction system of sponge titanium.
Heat and Mass Transfer,
Vol. 53,
Issue. 2,
p.
465.